Frigidaire FAQ055S7A Installation Instructions

Frigidaire FAQ055S7A - 5500 BTU Air Conditioner Manual

Get Frigidaire FAQ055S7A - 5500 BTU Air Conditioner PDF manuals and user guides View all Frigidaire FAQ055S7A manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FAQ055S7A manual content summary:

  • Frigidaire FAQ055S7A | Installation Instructions - Page 1
    and parts before starting Installation. Read and follow the instructions provided air conditioner. NOTE: Do not use an extension cord. • Free movement of air fn room to be cooled. • A large enough opening for the air conditioner. • Adequate wall support for weight of air conditioner Air conditioner
  • Frigidaire FAQ055S7A | Installation Instructions - Page 2
    Window Installation Window opening measurements: ■ 22.2" to 40' (56.3 cm to 101.6 cm) opening width, ■ 14' (35.5cm) minimum opening height A 1► B i i I J A. 22.2" (56.3 cm) minimum B. MC (35.5cm) minimum Through-the-Wall Installation The wall opening measurements should be: ■ Width: 191/ie
  • Frigidaire FAQ055S7A | Installation Instructions - Page 3
    INSTALLATION INSTRUCTIONS Unpacking Excessive Weight Hazard Use two or more people to move and install air conditioner. Failure to do so can result in back or other injury. 4. Remove the window lock bracket and screw from the air conditioner and set aside.(on some models) Remove packaging
  • Frigidaire FAQ055S7A | Installation Instructions - Page 4
    Phillips screws into the top and bottom slots of curtain. Screw the curtain to the top and bottom holes in the air conditioner cabinet 5. Slide the curtain housing into the curtain guides as far as it will go. 6. Repeat the above steps for the left-hand curtain. Attach foam adhesive seal Attach foam
  • Frigidaire FAQ055S7A | Installation Instructions - Page 5
    opening during installation or removal. • The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 W pan-head Phillips screws B. Windowsill 6. Check that air conditioner cabinet is tilted to the outside so that water will run to the outside. 5
  • Frigidaire FAQ055S7A | Installation Instructions - Page 6
    " for dimensions. 2. Measure the outside width and height of frame to determine wall opening dimensions. 3. Cutthe opening through the wall. Remove and save insulation. NOTES: ■ Dimension for depth depends on wall thickness and type of molding. ■ Do not block louvers in air conditioner cabinet 6
  • Frigidaire FAQ055S7A | Installation Instructions - Page 7
    sure the free end of the ground wire is outside of the cabinet Excessive Weight Hazard Use two or more people to move and Install air conditioner. Failure to do so can result in back or other Injury. A A. Make sure the free end of the ground wire is outside of the cabinet
  • Frigidaire FAQ055S7A | Installation Instructions - Page 8
    up. Put excess ground wire between coil and air conditioner cabinet. 5. lnsertfront tabs of front panel into top of cabinet and swing front into place. 6. Attach bottom front of panel with front panel screws. Replace control knobs (on some models), 1111111111111111111111111111111.-11.1111111
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
INSTALLATION
INSTRUCTIONS
Tools
and
ik
Gather
the
required
tools
and
parts
before
starting
Installation.
Read
and
follow
the
instructions
provided
with
any
tools
listed
here.
Tools
Needed
•
Flat
-blade
and
Phillips
•
Tape
measure
screwdrivers
•
Level
•
Drill
and
3
132'
or
smaller
bit
Through
-the-Wall
Installation:
In
addition
to
the
tools
listed
above,
the
following
tools
are
needed
for
through
-the
-wall
Installation.
•
Saw
•
Wood
preservative
•
Caulk
•
1'
(2.5
cm)
or
thicker
lumber
■
#10
x
1'
wood
screws
(7)
Parts
Supplied
(on
some
models)
Check
that
all
parts
are
included
in
parts
package.
IT
CDEF
A.
Foam
window
sash
seal
B.
Window
lock
brackets
(I)
C.
/10x
W
pan
-head
Phillips
screws
(6)
D.
110x
W
pan
-head
Phillips
screws
(3)
0
H
E.
110x
W
round
-head
screws
(5)
F.110
x
lha
pan
-head
Phillips
screws
(2)
G.
Top
channel
H.
Side
curtains
(2)
L
Foam
seal
NOTE:
Installation
parts
are
supplied
for
double
-hung
windows
up
to
40'
(101.6
cm)
wide.
A
special
Wide
Window
Kit
is
available
from
your
dealer
or
service
center.
See
'Accessories.'
Location
Requirem
IMPORTANT:
Observe
all
governing
codes
and
ordinances.
Check
the
location
where
air
conditioner
will
be
installed.
Proper
installation
is
your
responsibility.
Make
sure
you
have
everything
necessary
for
correct
installation.
The
location
should
provide:
•
Grounded
electrical
outlet
within
4
ft
(122
cm)
of
where
the
power
cord
exits
the
air
conditioner.
NOTE:
Do
not
use
an
extension
cord.
•
Free
movement
of
air
fn
room
to
be
cooled.
•
A
large
enough
opening
for
the
air
conditioner.
•
Adequate
wall
support
for
weight
of
air
conditioner
Air
conditioner
weighs
between
50
and
60
lbs
(22
to
28
kg).
NOTE:
Cabinet
louvers
must
not
be
obstructed.
Air
must
be
able
to
pass
freely
through
the
cabinet
louvers.
A
11
r`r44!
•
11
A.
Cabinet
louvers
P/N
66129901290
1