Frigidaire FFHT1725PS Installation Instructions (All Languages)

To be removed by the customer after installation is complete

INSTALLATION CHECKOFF LIST

Doors

Handles are secure and tight

Door seals completely to cabinet on all sides

Freezer door is level across the top

Leveling

Refrigerator is level, side to side and tilted 1/4” (6mm) front to back

Toe grille is properly attached to refrigerator

Cabinet is setting solid on all corners

Electrical Power

House power turned on

Refrigerator plugged in

Ice Maker

House water supply connected to refrigerator

No water leaks present at all connections - recheck in 24 hours

Ice Maker is turned ON.

Final Checks

Shipping material removed

Fresh Food and Freezer controls set

Crisper Humidity controls set

Registration Card sent in

Refer to your

Owner’s Use and Care Manual

for

additional information about your refrigerator.

•

Load refrigerator from side of cabinet only.

•

Do not run retaining straps over handles.

•

Do not over-tighten retaining straps.

•

Never use refrigerator handles to move the

refrigerator.

•

Remove tape from doors only after unit is in

place.

HAND TRUCKING

1

Remove Shipping material. (Features may vary per model.)

2

SHIPPING MATERIAL

3

Connect water supply - check for water

leaks.

Turn icemaker OFF if water supply

is not connected immediately.

Connecting to a reverse osmosis system

is not recommended.

WATER SUPPLY

eçìëÉ

éäìãÄáåÖ

äáåÉ

t~íÉêäáåÉ Üççâìé

_É ÅÉêí~áå

íÜÉ ï~íÉê î~äîÉ áë

çéÉå ~åÇ íÜÉêÉ

~êÉ åç äÉ~âëK

qÜÉ ï~íÉê î~äîÉ

çå íÜÉ Ä~Åâ çÑ

íÜÉ êÉÑêáÖÉê~íçê

ïáää `äáÅâL_ìòò áÑ

íÜÉ ï~íÉê î~äîÉ

áë ÅäçëÉÇK

4

Allow the following clearances for ease of installation, proper air circulation, and

plumbing and electrical connections:

•

Sides & Top

..........

3/8”

•

Back

.......................

1”

INSTALLATION CLEARANCES

NO

NO

NO

NO

NOTE

TE

TE

TE

TE

If you are installing your refrigerator beside a wall, leave 1/2” minimum between

hinges and wall to allow for the door to swing open.

5

All four corners of your refrigerator must rest firmly on a solid floor. Your refrigerator

is equipped with adjustable front rollers or front leveling screws to help level your

unit.

To level cabinet or change door height:

1. Remove toe grille.

2.

Use flat-blade screwdriver or 3/8” socket wrench to adjust front rollers. Use

adjustable wrench to adjust leveling screws.

LEVELING AND ADJUSTING

NO

NO

NO

NO

NOTE

TE

TE

TE

TE

Raise the front of the refrigerator enough so the doors close freely when opened

halfway. The refrigerator should slope ¼” to ½” from front to back. Then level the

refrigerator from side to side.

6

Toe Grille

Adjustable Front Roller

(some models)

Raise

Stationary Front Roller

with Leveling Screw

(some models)

When changing controls, wait 24

hours before making additional

adjustments.

CONTROLS

7

Ensure icemaker

is turned ON.

8

ICEMAKER

DOOR

REMOVAL

(IF NECESSARY)

IF YOU ARE DISSATISFIED WITH THE

INSTALLATION, PLEASE CALL THE STORE

YOU PURCHASED IT FROM.

9

√

See “Normal Operating Sights & Sounds”

in the

Use & Care Manual

so you understand the sounds you may hear once your refrigerator is

running.

√

Please read entire

Use & Care Manual

to become aware of important

safety instructions and to become familiar witrh your new refrigerator.

√

Send in Registration card

to register your refrigerator.

√

Congratulations!

You are ready to enjoy your new refrigerator.

P/N: 240568304

Humidity

Control

Center

Hinge

Shim

Pin

Top Hinge

Cover

Top Hinge

If you need to remove the doors to get your refrigerator

into the house please see “Door Removal and Reversal

Instructions” in your

Use & Care Manual.

Bottom

Water Tube

Cable

Wood

Top Hinge

Cover

Top Hinge

OR

(For models with LED display, 3 to 5 is normal operating range.)

Frigidaire FFHT1725PS Installation Instructions (All Languages)

Frigidaire FFHT1725PS Manual

Frigidaire FFHT1725PS manual content summary: