Frigidaire FFRE0833U1 Installation Instructions

Frigidaire FFRE0833U1 Manual

Get Frigidaire FFRE0833U1 PDF manuals and user guides View all Frigidaire FFRE0833U1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FFRE0833U1 manual content summary:

  • Frigidaire FFRE0833U1 | Installation Instructions - Page 1
    Installation Instructions READ BEFORE INSTALLING UNIT BS Window Mounting (8,000 BTU) INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. be exposed: Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the
  • Frigidaire FFRE0833U1 | Installation Instructions - Page 2
    . 3 Top Rail Bottom Rail Cut the seal foam(adherent type) into proper length. Then stick the seal foam at the lower part of the window frame. Your air conditioner is designed to install in standard double hung windows with opening widths of 24 to 36 inches (609 mm to 914 mm) (FIG. 4A & FIG
  • Frigidaire FFRE0833U1 | Installation Instructions - Page 3
    Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6A FIG. 6B
  • Frigidaire FFRE0833U1 | Installation Instructions - Page 4
    Installation Measure the width of the inner side curtain with the provided Peel off the protecting film behind the insulation panel and stick the panel on the side curtain, as shown (FIG.12). Repeat these instructions for the other side. L L 1 2 3 4 1 2 3 4 5 6 7 8 9 10 11 FIG. 10 L
  • Frigidaire FFRE0833U1 | Installation Instructions - Page 5
    screws installed through frame and framelock. Remove the insulation panel and close (slide) side panels into frame. Keeping a firm grip on air conditioner, raise sash and carefully remove. Be careful not to spill any condensate water while lifting unit from window. Store parts WITH air conditioner
  • 1
  • 2
  • 3
  • 4
  • 5
READ BEFORE INSTALLING UNIT
BS Window Mounting (8,000 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
The top rail on your unit may already be installed. If not,
follow the steps below.
Top Rail Hardware
Qty.
4
1
Top Rail
Drill (If pilot holes are needed)
7
1
Mounting Hardware
Qty.
2
(For Vinyl-Clad windows)
NOTE:
the best way to store unit during winter, or when not
in use.
2
(For Wooden windows)
Top Rail
Fig. C
weather seals
5
window sash seal foam
1
be exposed:
Carefully read the installation manual before beginning.
INSTALLATION WARNINGS AND CAUTION
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended
period of time.
66129926908
insulation panel
ruler
2
1
Fig. B