Frigidaire FFRE103ZA1 Installation Instructions
Frigidaire FFRE103ZA1 Manual
 |
View all Frigidaire FFRE103ZA1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Frigidaire FFRE103ZA1 manual content summary:
- Frigidaire FFRE103ZA1 | Installation Instructions - Page 1
Instructions READ BEFORE INSTALLING UNIT BR Window Mounting (10,000 - 12,000 BTU) INSTALLATION WARNINGS AND CAUTION Carefully read the installation manual before beginning. be exposed: Carefully inspect location where air conditioner will be installed. Be sure it will support 8 9 10 11 12 - Frigidaire FFRE103ZA1 | Installation Instructions - Page 2
Installation LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear. This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be - Frigidaire FFRE103ZA1 | Installation Instructions - Page 3
Installation Keep a firm grip on the air conditioner, carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6A FIG. 6B INSIDE OUTSIDE INSIDE - Frigidaire FFRE103ZA1 | Installation Instructions - Page 4
inner side curtain with the provided ruler, as shown (FIG. 10). Mark a line on the provided insulation panel according to side curtain, as shown (FIG.12). Repeat these instructions for the other side. L L 1 2 3 4 1 2 3 4 5 6 7 8 9 10 11 FIG. 10 L FIG. 11 FIG. 12 (FIG. 13). NOTE - Frigidaire FFRE103ZA1 | Installation Instructions - Page 5
Installation 10 Check that air conditioner is tilted back about 1/4" (tilted about 2º to 4º downward to the outside, see FIG. 15A & FIG. 15B). After proper installation, condensate should
-
1 -
2 -
3 -
4 -
5
 |
 |
READ BEFORE INSTALLING UNIT
BR Window Mounting (10,000 - 12,000 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
The top rail on your unit may already be installed. If not,
follow the steps below.
Top Rail Hardware
Qty.
4
1
Top Rail
Drill (If pilot holes are needed)
7
1
Mounting Hardware
Qty.
2
(For Vinyl-Clad windows)
NOTE:
the best way to store unit during winter, or when not
in use.
2
(For Wooden windows)
Top Rail
Fig. C
weather seals
5
window sash seal foam
1
be exposed:
Carefully read the installation manual before beginning.
INSTALLATION WARNINGS AND CAUTION
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit over an extended
period of time.
66129926910
insulation panel
ruler
2
1
Fig. B