Frigidaire FGF348KM Installation Instructions (All Languages)

Frigidaire FGF348KM Manual

Frigidaire FGF348KM manual content summary:

  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 1
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 2
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE IMPORTANT SAFETY INSTRUCTIONS • Be sure your range is installed and grounded properly by a qualified installer or service technician. • This range must be electrically grounded in accordance with local codes or, in their absence, with the National
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 3
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Tools you will need (Wear safety glasses when using tools): g) Materials you will need: • Pipe joint sealant that resists action of LP/Propane gas (Fig. h) • Gas line manual shut-off valve (Fig. i) • A new flexible metal appliance conduit (1/2" NPT
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 4
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE Installation with cabinets Check location where the range will be installed for proper electric and gas supply, and stability of the floor. The dimensions shown here must be used and are minimal unless otherwise stated. These measurements do not
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 5
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE 1 Install anti-tip bracket IMPORTANT SAFETY WARNING! To reduce the risk of tipping of the range, the range must be secured to the floor by properly installed antitip bracket and screws packed with the range. Failure to install the anti-tip bracket
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 6
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE 2 Provide an adequate gas supply. Please note: Operation at elevations above 2000 ft., appliance rating shall be reduced at the rate of 4 percent for each 1000 ft. above sea level. This appliance is pre-set to operate on 4" natural gas manifold
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 7
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE c. Tighten the gas supply fitting and/or appliance conduit adapter to external manual shut-off valve (See Fig. 8). e. Attach flexible appliance conduit to flare union adaptor on shut-off valve (See Fig. 8). f. Make sure the service shut-off valve
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 8
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE 5 Read the following electrical connection details before connecting electricity to range. Before servicing, disconnect electrical supply at circuit breaker, fuse or power cord. Electric requirements: A dedicated, properly grounded and polarized
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 9
    INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE 7 Check ignition of surface burners. Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. a. To check for proper ignition, push
  • Frigidaire FGF348KM | Installation Instructions (All Languages) - Page 10
    materials in this appliance. Refer to the warranty in your Use & Care Guide for our tollfree service number and address. Please call or write if you have inquiries about your range product and/or need to order parts. Model and serial number location The identification plate is located on the right
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10

1
INSTALLATION INSTRUCTIONS - FREESTANDING GAS RANGE
INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL
INSPECTOR'S USE. READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
Provide proper fuel type
Before proceeding:
Your range is factory preset to
operate on natural gas. If L.P. conversion is needed,
contact your local L.P. Gas provider for assistance.
The L.P. conversion kit may be located on the lower rear
back panel of the range. If no L.P. kit is provided, contact
your product dealer to obtain the correct L.P. conversion kit.
Refer to your serial plate
for applicable agency
certifications
If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY:
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch;
do not use any phone in your
building.
Immediately call your gas supplier
from a neighbor's phone.
Follow
the gas supplier's instructions.
• If you cannot reach your gas
supplier, call the fire department.
Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Important notes to the installer
Read all instructions contained in these installation
instructions before installing range.
Remove all packing material from the oven
compartments before connecting the gas and
electrical supply to the range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
Important notes to the consumer
Keep these instructions with your
Use & Care Guide
for future reference.
Be sure your range is installed and grounded properly
by a qualified installer or service technician.
S
pecial instructions for appliances inst
alled in the S
t
ate of
Massachusett
s:
This appliance can only be installed in the State of
Massachusetts by a Massachusetts licensed plumber or
gas fitter. When using a flexible gas connector, it must not
exceed 3 feet (36 inches) in length. A "T" handle type
manual gas valve must be installed in the gas supply line to
this appliance.
IMPORTANT SAFETY INSTRUCTIONS
Installation of this range must conform with local codes or,
in the absence of local codes, with the National Fuel Gas
Code ANSI Z223.1—latest edition when installed in the
United States.
When installed in a manufactured (mobile) home,
installation must conform with the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
[formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD (Part 280)] or, when
such standard is not applicable, the Standard for
Manufactured Home Installations, ANSI/NCSBCS A225.1,
or with local codes.
This range has been design certified by CSA International.
As with any appliance using gas and generating heat, there
are certain safety precautions you should follow. You will
find them in the
Use & Care Guide, read it carefully.
p/n 316903000 (1004)