Frigidaire FGRQ0633U1 Installation Instructions

Frigidaire FGRQ0633U1 Manual

Get Frigidaire FGRQ0633U1 PDF manuals and user guides View all Frigidaire FGRQ0633U1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire FGRQ0633U1 manual content summary:

  • Frigidaire FGRQ0633U1 | Installation Instructions - Page 1
    that may be exposed: Air conditioners covered in this manual pose an excessive weight support the weight of the unit overan extended period of time. Handle air conditioner with care. Make sure air conditioner does not fall during installation. NOTE: SAVE CARTON and these INSTALLATION INSTRUCTIONS
  • Frigidaire FGRQ0633U1 | Installation Instructions - Page 2
    4B) Lower sash must open sufficiently to allow a clear vertical opening of 14 inches (356 mm ). Side louvers and the rear of the air conditioner must have clear air space to allow enough airflow through the condenser, for heat removal. The rear of the unit must be outdoors, not inside a building or
  • Frigidaire FGRQ0633U1 | Installation Instructions - Page 3
    , carefully place the unit into the window opening so the bottom of the air conditioner frame is against the window sill (FIG. 6A & FIG. 6B). Carefully close the window behind the top rail of the unit. FIG. 6A FIG. 6B
  • Frigidaire FGRQ0633U1 | Installation Instructions - Page 4
    the frame smoothly, trim the insulation panel then try again, until the insulation panel fits the frame, as shown (FIG.12). Repeat these instructions for the other side. FIG. 10 1 2 3 4 5 6 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Measure the inner width of the side curtain or FIG
  • Frigidaire FGRQ0633U1 | Installation Instructions - Page 5
    any gaps found at the location as indicated by the arrows in Fig. 16. Vinyl-Clad Window FIG. 16 Removing the air conditioner From Window Turn the air conditioner off, and disconnect power cord. Remove sash seal from between windows, and unscrew sash lock. Remove screws installed through frame and
  • Frigidaire FGRQ0633U1 | Installation Instructions - Page 6
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
READ BEFORE INSTALLING UNIT
MSII
MSIII
Window Mounting (5,000~8,000 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is
the best way to store unit during winter, or when not
in use.
FOR SAFETY REASONS, THE TOP RAIL MUST BE
SECURELY FASTENED WITH ALL FOUR (4)
SCREWS.
A. Remove the air conditioner from the carton and place on a flat surface.
B. Remove top rail from the rear of the packaging material as shown in Fig. A
C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B
D. Secure the top rail to the unit with the 3/8
Ǝ
Screws as shown in Fig. C
Top Rail Hardware
Qty.
4
1
3/8
Ǝ
Screw
Top Rail
Some assembly is required. Please read these instructions
carefully.
Packaging
Fig. A
The unit is for window mounting only.
INSTALLATION WARNINGS AND CAUTION
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
Drill (If pilot holes are needed)
7
1
Mounting Hardware
Qty.
2
s)
2
(
or Wooden windows)
weather stripping
insulation panel
ruler
(10”X3/4”X1/12”)
5
window sash seal foam
1
2
1
16120300A11762
Top Rail