Frigidaire FPDF4085KF Installation Instructions (All Languages) - Page 9
When All Hookups are Complete, Before You Call for Service - gas range
UPC - 057112103433
View all Frigidaire FPDF4085KF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS (Models with Electric Ovens and Gas Cooktop) 3. Check the Igniters Operation of electric igniters should be checked after range and supply line connectors have been carefully checked for leaks and range has been connected to electric power. To check for proper lighting: a. Push in and turn a surface burner knob to the LITE position. You will hear the igniter sparking. b. The surface burner should light when gas is available to the top burner. Each burner should light within four (4) seconds in normal operation after air has been purged from supply lines. Visually check that burner has lit. c. Once the burner lights, the control knob should be rotated out of the LITE position. There are separate ignition devices for each burner. Try each knob separately until all burner valves have been checked. 4. Adjust the "LOW" Setting of Surface Burner Valves (see Figure 12) a. Push in and turn each control to LITE until burner ignites. b. Quickly turn knob to LOWEST POSITION. c. If burner goes out, readjust valve as follows: Reset control to OFF. Remove the surface burner control knob, insert a thin-bladed screwdriver into the hollow valve stem and engage the slotted screw inside. Flame size can be increased or decreased with the turn of the screw. Adjust flame until you can quickly turn knob from LITE to LOWEST POSITION without extinguishing the flame. Flame should be as small as possible without going out. 5. Operation of Oven Elements The oven is equipped with an electronic oven control. Each of the functions has been factory checked before shipping. However, it is suggested that you verify the operation of the electronic oven controls once more. Refer to the Use and Care Guide for operation. Follow the instructions for the Clock, Timer, Bake, Broil, Convection (some models) and Clean (some models) functions. When checking oven element operation, do not touch the elements. They will be hot enough to cause serious burns. Bake-After setting the oven to 350°F (177°C) for baking, the lower element in the oven should become red. Broil-When the oven is set to BROIL, the upper element in the oven should become red. Clean-When the oven is set for a self-cleaning cycle, the upper element should become red during the preheat portion of the cycle. After reaching the self-cleaning temperature, the lower element will become red. Convection-When the oven is set to CONV. BAKE/ ROAST at 350°F (177°C), both elements cycle on and off alternately and the convection fan will turn. The convection fan will stop turning when the oven door is opened during convection baking or roasting. When All Hookups are Complete Make sure all controls are left in the OFF position. Before You Call for Service Read the Avoid Service Checklist and operating instructions in your Use and Care Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. Refer to the warranty and service information in your Use and Care Guide for our phone number and address. Please call or write if you have inquiries about your range product and/or need to order parts. Figure 12 9