Frigidaire GHWW083WB1 Installation Instructions

Frigidaire GHWW083WB1 Manual

Get Frigidaire GHWW083WB1 PDF manuals and user guides View all Frigidaire GHWW083WB1 manuals
Add to My Manuals
Save this manual to your list of manuals

Frigidaire GHWW083WB1 manual content summary:

  • Frigidaire GHWW083WB1 | Installation Instructions - Page 1
    Instructions READ BEFORE INSTALLING UNIT MSII MSIII Window Mounting (5,000~8,000 BTU) INSTALLATION WARNINGS AND CAUTION The unit is for window mounting only. Carefully read the installation manual conditioner will be installed. Be sure it will support the weight of the unit overan extended period of
  • Frigidaire GHWW083WB1 | Installation Instructions - Page 2
    HIonwstotaInlsltaaltl ion LEFT + RIGHT FILLER PANEL ASSEMBLY NOTE: Top Rail and Side Panels at each side are offset to provide the proper pitch to the rear of (5/16"). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this
  • Frigidaire GHWW083WB1 | Installation Instructions - Page 3
    Installation Storm Window: If the air conditoner is blocked by Storm Window, add wood as shown in FIG. 5, or remove storm window before air conditioner is installed. If Storm Window Frame must remain, be sure the drain holes or slots are not caulked or painted shut. Accumulated Rain Water or
  • Frigidaire GHWW083WB1 | Installation Instructions - Page 4
    Installation Drive locking screws: A: For wooden windows: Drive 1/2 (12.7 mm) locking screws through the frame lock and into the sill (FIG. 9A). NOTE:To prevent window sill from splitting, drill 1/8 (3mm) pilot holes before driving screws. Drive 1/2 (12.7 mm) locking screws through frame holes
  • Frigidaire GHWW083WB1 | Installation Instructions - Page 5
    9 FIG. 12A & FIG. 12B). normal use, correct the slope otherwise. FIG. 12A Installation FIG. 12B H INSIDE OUTSIDE H INSIDE OUTSIDE H about Bottom Rail H1 Bottom Rail Wooden Window Vinyl-Clad Window 10 In order to minimize air leaks between the room air conditioner and the window opening,
  • 1
  • 2
  • 3
  • 4
  • 5
READ BEFORE INSTALLING UNIT
MSII MSIII Window Mounting (5,000~8,000 BTU)
1
Installation Instructions
Before installing, the top rail must be assembled on the unit.
DO NOT USE ANY SCREWS OTHER THAN
THOSE SPECIFIED HERE.
NOTE:
SAVE CARTON and these INSTALLATION
INSTRUCTIONS for future reference. The carton is
the best way to store unit during winter, or when not
in use.
FOR SAFETY REASONS, THE TOP RAIL MUST BE
SECURELY FASTENED WITH ALL FOUR (4)
SCREWS.
A. Remove the air conditioner from the carton and place on a flat surface.
B. Remove top rail from the rear of the packaging material as shown in Fig. A
C. Align the hole in the top rail with those on the top of the unit as shown in Fig. B
D. Secure the top rail to the unit with the 3/8
Screws as shown in Fig. C
Top Rail Hardware
Qty.
4
1
3/8
Screw
Top Rail
Some assembly is required. Please read these instructions
carefully.
Packaging
Fig. A
The unit is for window mounting only.
INSTALLATION WARNINGS AND CAUTION
Pay attention to danger and safety notices.
To avoid risk of personal injury, property damage, or product damage due to the weight of this device and sharp edges that may
be exposed:
Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install
the unit. Wear protective gloves whenever lifting or carrying the unit. AVOID the sharp metal fins of front and rear coils. To
prevent injury or strain, use proper lifting and carrying techniques when moving unit.
Carefully inspect location where air conditioner will be installed. Be sure it will support the weight of the unit overan extended
period of time.
Handle air conditioner with care.
Make sure air conditioner does not fall during installation.
Carefully read the installation manual before beginning.
Follow each step as shown.
Observe all local, state, and national electrical codes and by qualified, licensed, authorized personnel only.
Drill (If pilot holes are needed)
7
1
Mounting Hardware
Qty.
2
s)
2
(
or Wooden windows)
weather stripping
(10”X3/4”X1/12”)
5
window sash seal foam
1
16120300A21175
T
op Rail