Fujitsu EA4000 Owners Manual

Fujitsu EA4000 Manual

Get Fujitsu EA4000 PDF manuals and user guides View all Fujitsu EA4000 manuals
Add to My Manuals
Save this manual to your list of manuals

Fujitsu EA4000 manual content summary:

  • Fujitsu EA4000 | Owners Manual - Page 1
    IIIQf1 0 0 IllID6ED _ UU •.'USE TT.AEIlOIE GICI 10001 LJ- 0 o o EA4000 L'ECLIPSE o uuu Thank you for purchasing the EA2000(2 channel) I EA4000(4 Channel) Intergrated Series Power Amplifier. Please read this Owner's Manual before use. Be sure to read the Safety information section. Keep
  • Fujitsu EA4000 | Owners Manual - Page 2
    EA Series Amplifiers 3 About Your Amplifier 4 Installation Requirements 5 Power Amplifier Adjustments and Tuning 6 Names and Functions of Terminals 9 Basic System Connection 10 AVN Connection Examples 11 Head Unit Connection Examples 12 Troubleshooting 13 Specifications 16 -2-
  • Fujitsu EA4000 | Owners Manual - Page 3
    For your safety in using the EA Series Amplifier Warnings and caution signs, illustrated below, are posted throughout this manual as well as on the EA2000/EA4000. They show safe and correct ways to handle the product to prevent personal injury to you and others and to avoid damage to property.
  • Fujitsu EA4000 | Owners Manual - Page 4
    blown fuses with fuses of a higher current rating. This Amplifier requires maximum two 30 Amp fuses. (One 30 Amp fuse for EA2000 and two 30 Amp fuses for EA4000) Eclipse Power On Indicator: When the Power Amplifier is powered on the Eclipse Brand Logo will be Lighted. Clipping Indicators: Each
  • Fujitsu EA4000 | Owners Manual - Page 5
    Start: Congratulations on your purchase of this Eclipse Power Amplifier. The proper installation and system integration of this Power Amplifier will bring the optimum conditions for high performance and a long trouble free life for your Mobile Audio System. Please pay attention to the Installation
  • Fujitsu EA4000 | Owners Manual - Page 6
    will allow you to set the Input Controls before physically installing the Amp in the car. If the Source Unit output Voltage Specification is 4 Volts, start by setting the gain controls to about 5 Volts before installing the Amplifier. 2. Mono Switch: The Mono switch is in the OFF Position when the
  • Fujitsu EA4000 | Owners Manual - Page 7
    Woofer or Overdriving the Amplifier or both. The Clipping indicator is a good guide to use when setting the boost level. 6. Detailed Tuning: For the best overall results it is highly recommended that fine tuning of your Audio System should be done by an Authorized Eclipse Dealer. After initial setup
  • Fujitsu EA4000 | Owners Manual - Page 8
    one channel at a time so the Peak Indicators on the Amplifier are just on during peaks. Listen for acceptable levels of distortion. 12. Adjust the Input Gains on the Amplifiers so the Front-Rear and Left-Right Balance sounds correct. 13. Depending on the sound, you may wish to make small adjustments
  • Fujitsu EA4000 | Owners Manual - Page 9
    Right + Speaker Out Left - I I I + BRIDGED - Speaker Out Right - I I I lIHf PREAMP IN OUT r - - - - - Left PreAmp Output I f Right PreAmp Output EA4000 Power Connections Signal Input Connections FUSE @ 30' 30' +6ATT. REMOTE GND. 00 0 0 rLiNE [N1 FRONT REAR PREAMt OUT Left Front
  • Fujitsu EA4000 | Owners Manual - Page 10
    +LEFT_ +"IGHT_ + BRIDGED , r==="J , + . , r==="J + -I Front / Rear ~ol JON Mono LJ lOFF Speaker Connections 4 Channel EA4000 Front Rear ~ol JON Mono LJ 1 OFF Mono ~~JON LJ 1 OFF Speaker Connections 3 Channel SPEAKER OUT FRONT +lEFT_ +RIGHT_ Front / Rear ~ Mono JON il LJ lOFF Speaker
  • Fujitsu EA4000 | Owners Manual - Page 11
    E8.. : Non-Fader Out EA2000 ' : ~~ 1 I==F======:l I ,, Front Left Speaker Left Channel Right Channel Front Right Speaker Rear Left Speaker Front Rear Right Speaker Rear AVN Connections EA4000 example of 3 channel install EA4000 . •• Front Out Non-Fader Out Sub Front AVN connection using
  • Fujitsu EA4000 | Owners Manual - Page 12
    Rear Left Speaker Rear Right Speaker --'~ Front Rear AVN Connections EA4000 example of 3 channel install EA4000 •• Sub Front Out rD '-------1Lo Non-Fader Out Front Head Unit connection using the EA2000 and EA4000 EA2000 Bridged Non Fader Out OOlooot Front EMOOO •• -= ~- OOlo;or
  • Fujitsu EA4000 | Owners Manual - Page 13
    refer to this troubleshooting section for solutions. If after carefully following these instructions you still have a problem, please contact Eclipse Technical Supporl at 1-800-233-2216 Problem Possible Cause Possible Solution 1. Amp won't power on No fuse installed in the amplifier or fuse
  • Fujitsu EA4000 | Owners Manual - Page 14
    the impedance between the Barrel of the RCA and the amp power ground. If no negative speaker lead short, the impedance is nearly shorted (low resistance). Call Eclipse Technical support. 6. Distorted Output Amplifier gain is too high Turn amplifier gain down so clipping LED turns on during peaks
  • Fujitsu EA4000 | Owners Manual - Page 15
    Problem Possible Cause Possible Solution 9. Speaker pops when Source unit may be sending pop noise to unit is turned on or off amplifier Disconnect proper ventilation: Check load impedance against the specifications: Connect the proper load impedance. 12. Amp won't shut off Remote on wire is
  • Fujitsu EA4000 | Owners Manual - Page 16
    @ 20 Hz Signal to Noise ( CEA 2006 ) > 100 dB Frequency Response 20Hz - 20KHz +0, -.5 dB Channel Separation < 70 dB Damping Factor EIA / IHF > 50 dB Quiescent Current ( Idle Current) :: 1 Amp Maximum Current EA2000 30Amps EA4000 60Amps Amp Protect Temperature (Heat Sink) 90C - 16 -
  • Fujitsu EA4000 | Owners Manual - Page 17
    - 17 -
  • Fujitsu EA4000 | Owners Manual - Page 18
    - 18 -
  • Fujitsu EA4000 | Owners Manual - Page 19
    - 19 -
  • Fujitsu EA4000 | Owners Manual - Page 20
    serial number of your new Amplifier for identification. The serial number is labeled or stamped on the chassis. Serial No. FUJITSU TEN LIMITED Contact: FUJITSU TEN CORP.OF AMERICA 19600 So. Vermont Avenue, Torrance, CA 90502 800·233·2216 www.eclipse-web.com "ECLIPSE" is a registered trademark of
  • Fujitsu EA4000 | Owners Manual - Page 21
    LECLIPSE IMPORTANT SHOULD YOU HAVE ANY QUESTIONS, call: 1-800-233-2216 OJ FUJITSU TEN FUJITSU TEN CORP. OF AMERICA 19600 S. Vermont Avenue, Torrance, CA 90502 PLACE FIRST-CLASS STAMP HERE FUJITSU TEN CORP. OF AMERICA Warranty Registration 19600 S. Vermont Avenue Torrance, CA 90502
  • Fujitsu EA4000 | Owners Manual - Page 22
    or serVice by non-authorized Eclipse Service Department, use of component parts not approved by Eclipse Damage caused In transit or in handling, or when the model's serral number has been removed, altered Or defaced 3. Cosmetic damage accessorres (SUCh as magazines or remotes) or problems or
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
ECLIPSE®
EA2000/EA4000
Ownerls Manual
2/
4
Channel
Integrated
Series
Power
Amplifier
0
0
EA2000
L'ECLIPSE
,,,.~.
~.
0.
6
100>
u
_
"""'"
0
01'
LOW'OSI
"'ASI
~~,
",
SPEAKER
001
00
19°0-01
TT.AEIlOIE
GICI
00
lIIl
PIIU'"
'"
~
'USE
10001
UTIO
0
•.
~
I'tZSlO:IO
!OO
IIIQf1
0
0
IllID6ED
_
-
-0
-
UU
LJ-
0
o
o
EA4000
L'ECLIPSE
uuu
o
Thank you for purchasing the EA2000(2 channel)
I
EA4000(4 Channel) Intergrated Series Power Amplifier.
Please read this Owner's Manual before use. Be sure to read the Safety information section.
Keep this Owner's Manual together with the Warranty information
in
a safe place for later reference.