Fujitsu S6520 S6520 Getting Started Guide

Quick Tips

It takes approximately 4 hours to

charge a fully discharged single

battery with unit off or in

suspend mode.

Optimizing Battery Life

• Set power management setting

to Maximize Battery Life.

• Adjust display brightness levels

to lowest comfortable setting.

• Remove PC Card when

not needed.

• Utilize Suspend mode when

not using your notebook.

• Read the Power Management

section in your electronic User’s

Guide for additional features.

Adjusting Display Brightness

• Fn + F6 to decrease brightness

• Fn + F7 to increase brightness

Adjusting Volume

• Fn + F8 to decrease volume

• Fn + F9 to increase volume

* Mono microphone jack or stereo

microphone/line in jack depending

on configuration.

* *

Stereo headphone/Optical Digital

Audio out jack or stereo head-

phone/Line Out/Optical Digital

Audio out jack.

Drivers

Look for the latest drivers on the

Drivers and Applications Restore

CD. Right-click the FDU icon and

select “update”, or download

them at us.fujitsu.com/computers.

This convenient guide will lead you through the start-up

process and will also offer some valuable tips.

1. Open the Display Panel

Ensure that your LifeBook is on a hard level surface and that

•

the air vents are not blocked.

Press latch button and lift the display, being careful not to

•

touch the screen.

Adjust the display until it is at a comfortable viewing angle.

•

2. Connect AC Power

Plug the AC adapter into your notebook.

•

Plug the power cord into the AC adapter.

•

Connect the power cord to an electrical outlet.

•

3. Connect to Internet or Network

Connect either a phone cord to the modem jack or an Ethernet

•

cable to the LAN jack on your notebook and to a wall jack

or to an Ethernet router.

4. Booting the System

Important:

During the setup procedure, do not disconnect the power supply,

•

press any buttons, or use any peripheral devices such as a

mouse, keyboard, or remote control.

•

You should not attach any external devices and do not put a DVD/CD in

your drive until you have gone through the initial power on sequence.

Press the Suspend/Resume/Power button (above the keyboard) to

•

turn on the notebook. When you do this for the first time, it will display

a Fujitsu logo on the screen. If you do nothing the system will load

the operating system, and then the Windows Welcome will begin.

5. Register

For Genuine Microsoft

®

Windows

®

XP:

After the operating system has initialized, enter the information

•

as prompted to personalize your notebook and configure your

modem to dial.

For Genuine Windows Vista®:

Accept the Microsoft

•

®

Windows

®

Licensing Agreement and the

Fujitsu End User License Agreement to proceed.

Select your User ID and Password during the “Welcome Screen.”

•

•

Keep a record of your User ID and password stored in a secure place.

•

THE SCREEN WILL GO DARK FOR APPROXIMATELY TWO MINUTES.

Do not attempt to turn power on or off during this stage.

•

6. Registering Your LifeBook notebook

Register your notebook with Fujitsu Service and Support via our

•

website at us.fujitsu.com/computers.

You will need to be set up with an Internet Service Provider (ISP)

•

to register online.

7. Installing Click Me!

Check to be sure the WLAN switch is on.

•

For Genuine Microsoft

®

Windows

®

XP:

The first time you boot up

your system, you will see an icon called Click Me! in the Start menu.

For Genuine Windows Vista®:

In addition to an icon on the

desktop, a dialog box will automatically open that prompts you

to run Click Me!. If you choose not run ClickMe! at this time,

the ClickMe! icon will appear on your desktop.

When you click the Click Me! icon, your system will automatically

•

build the icon tray in the bottom right of the screen. These icons

provide links to utilities that you will frequently access.

Power Indicator

The Power indicator symbol shows whether

your system is operational. It has several

different states, each of which tells you

the mode your notebook is in.

Steady On: This means that there is power

to your notebook and that it is ready for use.

Flashing: This means that your notebook

is in Standby mode.

Steady Off: This means that your system is

either in Hibernate mode, or that your

notebook has been turned off.

If you are charging your battery, the Power

indicator will remain on even if your notebook

is shut off.

AC Adapter Indicator

The AC Adapter indicator states whether your

notebook is operating from the AC adapter,

Auto/Airline adapter or battery. This icon has

two different states that can tell you what

power source your notebook is using.

On: This means that either of the adapters

are currently in use.

Off: Power is only coming from the battery and

you do not have an adapter connected.

Battery Charge Indicators

Note that there are indicators for the primary

battery (Battery 1) and an optional second

battery (Battery 2).

Orange, solid: Battery is available and system

is charging.

Green, solid: Battery is available and system

is fully charged.

Orange, blinking: Battery is available and

waiting to charge battery (battery is out

of thermal range).

Off: AC adapter is not plugged in.

Battery Level Indicators

Note that there are indicators for the primary

battery (Battery 1) and an optional second

battery (Battery 2).

The Battery Level indicators display the charge

level of the indicated battery pack, as follows:

Green, solid: Battery is between 51%

and 100% charged.

Orange, solid: Battery is between 13%

and 50% charged.

Red, solid: Battery is 12% or less charged.

Orange, blinking: Blinks during battery status

measurement (Four seconds after the

battery is installed).

Red, blinking: There is a problem with the battery.

Off: There is no battery installed, the

battery has no charge, or the system

has been turned off.

Hard Drive/Optical Drive Access

Indicator

The Hard Drive/Optical Drive Access indicator

glows green when your internal hard drive is

being accessed. Note that flickering is normal.

NumLk Indicator

The NumLk indicator states that the integral

keyboard is set in ten-key numeric

keypad mode.

CapsLock Indicator

The CapsLock indicator states that your

keyboard is set to type in all capital letters.

ScrLk Indicator

The ScrLk indicator states that your scroll

lock is active.

Common Indicators

LEFT PANEL

BOTTOM PANEL

RIGHT PANEL

BACK PANEL

CLICK ME

“Click Me!”

(For Additional Utilities)

Controls, Connectors,

and Access Points

Initial Start Up

Status Display Panels

The Status Display Panels are located above and below the

keyboard as shown. Following are some common indicators.

The Lithium ion battery is not charged upon purchase.

Initially you will need to connect either the AC adapter

or the Auto/Airline adapter to use your notebook.

What’s in the Box

Check to see that all of the following items are in the box:

❏

LifeBook notebook

❏

Drivers and Applications Restore DVD

❏

Lithium ion battery, pre-installed

❏

Microsoft

®

associated material

❏

AC adapter with power cord

❏

Recovery and Utility Disc

❏

Weight saver module

Depending upon your configuration, the following items may also be shipped with your notebook:

❏

Dual-Layer Multi-Format

❏

Additional Lithium ion battery

❏

DVD and/or CD-RW application CD

❏

Modular Bay Battery

Keyboard

Power/Suspend/Resume

Button

Status Indicator Panel

Status Indicator Panel

Touchpad Pointing Device

Display Panel

Microphone

Microphone

Web Camera

LAN (RJ-45) Jack

PC Card Eject Button

DC-In Jack

Air Vents

PC Card Slot

External Video

Port

IEEE 1394 Jack

8. Install Additional Software

Close any open programs, applications or utilities

•

Insert software application CD into media drive.

•

Open the application folder, select the set-up icon,

•

and load desired software, as shown in the table.

Restart your computer.

•

9. Access your User’s Guide

To take advantage of all the features of your new Fujitsu LifeBook

•

notebook, it is highly recommended that you read your electronic

User’s Guide. It contains important detailed information about

your new computer. You can access your User’s Guide by

selecting its icon from the screen desktop.

•

The Fujitsu Installer should automatically launch. If it doesn’t, you will

need to find the Setup.exe file on the Recovery CD’s root folder.

If you are using Genuine Windows Vista®, Click [Allow] in the

•

User Account Control (UAC) box.

Click [Continue]

•

•

Select “I Agree” and click [Continue] in the License Agreement box.

Select “User’s Guide” from the “Utilities/Applications” category.

•

Click [Install Selected Subsystems]

•

The User’s Guide will be copied to your hard drive in the

•

C:\Fujitsu\Manual directory. Shortcuts to the User’s Guide

will be placed on your desktop and in the Start menu.

Power/Suspend/Resume

Button

Infrared Port

Memory Stick/SD/xD Card Slot

Fingerprint Sensor

Display Panel Latch Button

S-Video Out Jack

LifeBook Security/Application

Panel

Stereo Speaker

Stereo Speaker

Lithium ion Battery Bay

Air Vents (multiple

locations)

Wireless LAN/Bluetooth

On/Off Switch

Memory Upgrade

Compartment

* Removable

Dust Filter

* Should be cleaned periodically

Flexible Bay

Device Lock

Battery

Release

Latches

Headphone Jack

Microphone Jack

USB Ports

Air Vents

USB Port

Anti-Theft Lock Slot

Anti-Theft Lock Slot

Modem Jack

Optical Drive Release Button

Flexible Bay (shown with Optical Drive installed)

WLAN

Switch

Display Panel

Latch Button

DC Power

Jack

AC Adapter

Telephone

Jack

LAN Jack

If you have a:

You will need to install

the following software:

Webcam

Arcsoft WebCam

Companion

Dual-Layer Multi-Format

CyberLink PowerProducer

DVD Writer

(FDU)

(For Latest Drivers)

Fujitsu S6520 S6520 Getting Started Guide

Fujitsu S6520 - LifeBook - Core 2 Duo 2.4 GHz Manual

Fujitsu S6520 manual content summary: