Garmin Astro DC 30 Battery Replacement Instructions

Astro

™

System DC 30

Battery, Collar, and Antenna Replacement Instructions

This document provides the following instructions.

Replacing the DC 30 Lithium‑ion Battery

Replacing the DC 30 Collar (page 2)

Replacing the VHF Antenna (page 2)

These kits are intended as replacement items for the Garmin

®

Astro

™

Dog Tracking System.

NOTE:

The limited warranty covering this product will not cover any replacement battery, collar, or

antenna not replaced in accordance with these instructions.

Replacing the DC 30 Lithium‑ion Battery

The DC 30 Battery Replacement Kit includes the following parts:

One rechargeable lithium‑ion battery

Two battery‑cover screws (M1.7 × 0.6 × 5 mm)

Four bottom‑cover mounting screws (M2.0 × 0.4 × 8 mm), stainless steel, black oxide

Tools required

(not included)—one small Phillips screwdriver and a small flat‑blade screwdriver.

NOTE:

It is not necessary to disconnect the DC 30 from the mounting plate on the collar to

replace the battery.

To remove the DC 30 lithium‑ion battery:

1. Use a small Phillips screwdriver to remove the four top‑cover screws from the top cover.

2. Separate the top cover from the bottom cover.

3. Use a small, flat‑blade screwdriver to disconnect the six‑pin connector from the top

cover.

4. Use a small, flat‑blade screwdriver to disconnect the two‑pin connector

from the bottom cover.

5. Use a small Phillips screwdriver to remove the two battery‑cover screws.

6. Remove the battery cover and the battery from the bottom cover.

Note the orientation of the battery in the bottom‑cover housing. You will

install the new battery the same way. Dispose of the old battery according

to local ordinances and regulations.

To replace the DC 30 lithium‑ion battery:

1. Place the replacement battery in the bottom cover. Place the wired end of the

battery on the same end as the

Power key on the bottom cover.

2. Attach the battery cover to the bottom cover using the two battery‑cover screws.

3. Connect the replacement‑battery two‑pin connector to the bottom cover.

4. Connect the replacement‑battery six‑pin connector to the top cover by using your thumb to hold the connector against

the housing, as shown in the illustration.

5. Check to ensure proper operation of the replacement battery by pressing the circuit‑board switch. If the red LEDs on

the bottom cover do not begin flashing, check the six‑pin connector for proper connection.

6. Check the charging circuit by connecting the Astro System DC 30 battery charger to an appropriate electrical source

and to the battery‑charging port. If the blue LED is not on, check the two‑pin connector for proper connection.

7. Firmly attach the top cover to the bottom cover using the four top‑cover screws to ensure water resistivity.

8. Fully charge the DC 30 battery before using it as described in the

Astro 220 Owner’s Manual

. Charging a fully

depleted DC 30 battery requires 4½ hours.

August 2008

190‑00714‑03 Rev. B

Printed in Taiwan

VHF antenna

GPS antenna

DC 30

Mounting plate

Top-cover screws

Top cover

Bottom cover

Two-pin

connector

Six-pin

connector

Battery cover

Battery-cover

screws

Power

key

Circuit-board

switch

Battery

‑

charging

port

Battery

Six-pin

connector