Garmin GTN 650 Pilot's Guide - Page 227

NOTE: Cell mode uses a clustering program to identify clusters of electrical activity that indicate cells. Cell mode is most useful during periods of heavy storm activity. Displaying cell data during these periods frees the user from sifting through a screen full of discharge points and helps to better determine where the storm cells are located. Foreword Getting Started Xpdr Ctrl 11.2.4 Changing the StormScope® Data Display Com/Nav Range StormScope data can be displayed on the Map page 2000 NM zoom scale, FPL but the data only goes out as far as the StormScope can report (200 nm). The 500 NM zoom scale will display all lightning data. Scales greater than 500 NM Direct-To do not display any additional StormScope data. Proc 1. While viewing the StormScope page, touch the In and Out keys to display a larger or smaller area. Wpt Info 11.2.5 Displaying StormScope® Data on the Map Map Page The Map Page displays cell or strike information using yellow lightning Traffic strike symbology overlaid on a moving map. This added capability improves situational awareness, which in turn makes it much easier for the pilot to relate Terrain storm activity to airports, navaids, obstacles and other ground references. Weather NOTE: StormScope data is displayed on the Map Page only if aircraft heading is available. Nearest 1. On the Home page, touch the Map key. Music 2. Touch the Menu key. Utilities System 3. Touch the StormScope key to enable StormScope lightning display on the Map page. Repeated touches toggle between Messages Off, Cell, and Strike. Symbols Appendix Index 190-01004-03 Rev. B Garmin GTN 625/635/650 Pilot's Guide 11-29