Garmin GTN 650 Pilot's Guide - Page 265
Point-To-Point Mode
View all Garmin GTN 650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 265 highlights
- If the active flight plan is selected the ETA reflects the current position of the aircraft and the current leg being flown. The ETA is calculated Foreword by adding to the current time the ETEs of the current leg up to and Getting including the selected leg. If the entire flight plan is selected, then the Started ETA is calculated as if the last leg of the flight plan was selected. Xpdr Ctrl • En Route safe altitude (ESA) - The ESA is shown as nnnnnFT Com/Nav • Destination sunrise and sunset times - These times are shown as hours:minutes and are the local time at the destination. FPL 14.4.1 Point-To-Point Mode The Trip Planning Point-to-Point mode shows trip calculations between two Direct-To selected points: either two waypoints from the database or from your present Proc position to a selected waypoint. 1. While viewing the Utilities page, touch the Trip Planning Wpt Info key. 2. Touch the Mode key to toggle to Point-to-Point. Map Touch To Select Touch To Select Departure Waypoint Arrival Waypoint Traffic Touch To Use Present Position As Departure Point Touch To Select P-to-P or Flight Plan Mode Terrain Weather Touch To Select Departure Time Touch To Toggle Between Statistics Nearest and Data Input Touch To Select Touch To Select Music Departure Date Expected Average Ground Speed Utilities Figure 14-15 Utility Trip Planning Page To Edit Input Data (Point-To-Point Mode) System Messages Symbols Appendix Index 190-01004-03 Rev. B Garmin GTN 625/635/650 Pilot's Guide 14-13