Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta Owners M
Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta Manual
 |
View all Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta manuals
Add to My Manuals
Save this manual to your list of manuals |
Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta manual content summary:
- Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 1
GHC™ 20 Owner's Manual - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 2
the written consent of Garmin. Garmin reserves the right to change or improve its products and to make changes in the content of this manual without obligation to notify any person or organization of such changes or improvements. Go to www.garmin.com for current updates and supplemental information - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 3
Table of Contents Introduction 1 Device Overview 1 Heading Screen 1 Standby Mode 1 Powerboat Autopilot Operation 1 Heading Hold 1 Engaging the Autopilot 1 Heading Adjustment 1 Enabling Shadow Drive 1 Adjusting Shadow Drive Sensitivity 1 Adjusting the Heading with the Helm 2 Selecting the - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 4
- Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 5
and Product Information guide in the product to the basic heading-hold functionality, the system allows manual steering and several modes of automatic-steering functions and . For information about installing, see the installation instructions for each device. Device Overview Heading Screen The - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 6
can adjust the heading using the helm (Enabling Shadow Drive, page 1). With the autopilot engaged, manually steer the boat. The autopilot activates Shadow Drive mode. When you release the helm and manually maintain a specific heading for a few seconds, the autopilot resumes a heading hold at the new - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 7
hold type, you must connect a NMEA 2000 or NMEA 0183 wind sensor to the autopilot. For advanced autopilot configuration, see the installation instructions included with your autopilot. 1 Select Menu > Setup > User Autopilot Setup > Wind Hold Type. 2 Select Apparent or True. Engaging Wind Hold Before - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 8
the Gybe Inhibitor NOTE: The gybe inhibitor does not prevent you from manually performing a gybe using the helm or step steering. The gybe inhibitor configured to act as a remote control for the helm control. See the instructions that came with the watch for more information. You can connect one - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 9
GHC Low Volt. Alarm: Sounds an alarm when the voltage of the power supply connected to the device drops below a specified level. Language: Sets the on-screen language. Operating Mode: Allows you to set the operating mode to normal or store demo mode. System Information: Allows you to view software - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 10
Index A autopilot 1, 4 C cloverleaf 3 cloverleaf pattern 3 D direction control 2, 4 display settings 4 G GPS steering 3 gybing. See tacking and gybing H heading 1, 2 adjusting 2 heading hold 1, 3 Shadow Drive 2 J jibing. 4 . See tacking and gybing See also tacking and gybing O orbit pattern 3 P - Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 11
- Garmin Reactor„¢ 40 Steer-by-wire Corepack for Volvo-Penta | Owners M - Page 12
support.garmin.com March 2020 TA-2012/1608 GUID-63975092-F9F4-45C0-841A-3A7E88168B91 v7
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
GHC
™
20
Owner’s Manual