Garmin StreetPilot I3 Set up and go

Set Up the i2/i3

Press and hold the

Power

button

to

turn on the i2/i3. Follow the instructions

on the screen to set up the i2/i3. Roll

the

Wheel

up and down to highlight

options. Press in to select options.

Install Software and Load Maps

1.

Insert the Setup DVD-ROM into your computer’s DVD-ROM

drive.

If the welcome screen does not automatically appear, click

Start

and then

Run

on your personal computer. Type the

letter of your DVD-ROM drive followed by setup.exe (example:

D:\setup.exe). Then press

Enter

.

2.

Follow the instructions on the screen to install software and

load maps to your i2/i3.

3.

When MapInstall opens, click the map to select the regions you

want to load to your i2/i3. Selected maps are shaded pink.

Find a Place and Go!

Select

Start Navigating

.

Select a destination.

Enjoy the route!

Select a category.

Select

Food, Hotels,

and More

.

Select

Where To?

Tip:

To narrow your search, select the

<Spell>

field and enter letters in the name of

the place.

Mount the i2/i3

1.

Place the suction cup mount on your windshield with the lever

pulled toward you, as shown above.

2.

Press the lever toward the windshield.

3.

Plug one end of the vehicle adapter into the USB port on the

i2/i3. Plug the other end into a receptacle in your vehicle.

Windshield

USB port

Lever

Power

Wheel

Getting Started

Insert Batteries

1.

Press down on the tab and pull to remove the battery door.

2.

Insert two AA batteries.

3.

Press down on the battery door as you slide it back into place.

Tab

Setup

DVD-ROM

Unlock sheet

USB cable

Vehicle adapter cable

i2/i3 and mount

WARNING:

For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the i2/i3 installed

to place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the

driver’s view of driving conditions, or cause personal injury in the event of an accident.

NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA:

State law prohibits drivers in California and

Minnesota from using suction mounts on their windshields while operating motor vehicles. Other Garmin dashboard or

friction mounting options should be used. Garmin does not take any responsibility for any fines, penalties, or damages that

may be incurred as a result of disregarding this notice. (See California Vehicle Code Section 26708(a); Minnesota Statutes

2005, Section 169.71)

Keep batteries installed in your i2/i3 so it can find satellites quickly.

Do not mix different types of batteries or old and new batteries.

NOTE:

Keep your Unlock sheet in a safe place for future reference.