Garmin Zumo 550 Installation Guide
Garmin Zumo 550 - Motorcycle GPS Receiver Manual
 |
UPC - 753759061753
View all Garmin Zumo 550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Garmin Zumo 550 manual content summary:
- Garmin Zumo 550 | Installation Guide - Page 1
connecting your audio system to the zūmo, be sure to consider the pathways needed to route the necessary cables. For information about hands-free audio and phone options, refer to the zūmo 500/550 Quick Reference Guide and the zūmo 500/550 Owner's Manual on disk. 2: Install the Handlebar Base The - Garmin Zumo 550 | Installation Guide - Page 2
TIP: When your zūmo is not in the mount, use the weather cap to prevent damage to the connector. More Information For more information about the zūmo, refer to the zūmo 500/550 Owner's Manual on disk. See the Important Safety and Product Information guide in the product box for product warnings and
-
1 -
2
 |
 |
WARNING:
The terms of the Garmin warranty require that the power cable with bare wire leads be
installed by experienced installers having the proper knowledge of automotive electrical systems and
skill in the use of special tools or hardware required for installation.
1: Connect Power to the Mount
Select a suitable and secure location to mount the zūmo on your motorcycle based on available
power sources and safe cable routing.
Bare wires with
inline fuse for
power connection
Power connector
About connecting audio
Standard jacks for microphone (2.5 mm) and audio out (3.5 mm) are located on the left side of
the mount (under a weather cap). When connecting your audio system to the zūmo, be sure to
consider the pathways needed to route the necessary cables. For information about hands-free
audio and phone options, refer to the
zūmo 500/550 Quick Reference Guide
and the
zūmo 500/550
Owner’s Manual
on disk.
2: Install the Handlebar Base
The zūmo includes parts for two handlebar installation
solutions. Custom mounts can require additional
hardware (www.ram-mount.com).
A) To install the U-bolt and handlebar base:
1.
Place the U-bolt around the handlebar, and thread
the ends through the handlebar base.
2.
Tighten the nuts to secure the base. Do not
overtighten.
NOTE:
The recommended torque is 50in-lb. Do
not exceed maximum torque of 80in-lb.
B) To install the handlebar base to
the clutch/brake clamp bracket:
NOTE:
Both 1/4” standard and M6
bolts are included. Match the size of
the factory bolts on your clutch/
brake clamp bracket.
1.
Remove the two factory bolts on your
clutch/brake clamp bracket.
2.
Thread the new bolts through the
handlebar base, spacers, and clamp bracket.
3.
Tighten the bolts to secure the base.
zūmo
™
500/550 I
nstallatIon
s
heet
Clutch/brake
clamp bracket
Handlebar
base
Spacers
Handlebar base
Handlebar
U-bolt
Garmin
®
is a trademark of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. zūmo
™
is a
trademark of Garmin Ltd. or its subsidiaries. These trademarks may not be used without the express permission of
Garmin.
March 2007
Part Number 190-00697-03 Rev. E
Printed in Taiwan