Garmin Zumo 660 Installation Instructions
Garmin Zumo 660 Manual
 |
UPC - 753759085087
View all Garmin Zumo 660 manuals
Add to My Manuals
Save this manual to your list of manuals |
Garmin Zumo 660 manual content summary:
- Garmin Zumo 660 | Installation Instructions - Page 1
zūmo 660 Installation Instructions Mount Your zūmo on the Motorcyle Warning: Incorrectly wiring the power cable with bare wire leads can result in damage to the vehicle or the battery and can cause bodily injury. Garmin strongly recommends having an experienced installer with the proper knowledge of - Garmin Zumo 660 | Installation Instructions - Page 2
B) To install the handlebar base to the clutch/brake clamp bracket: Note: Both 1/4 in. /brake clamp bracket Spacers Step 3: Attach the Base Plate to the zūmo Mount 1. Thread the M4 × 40 mm panhead screws through the washers, cradle, spacers, and base plate. 2. Tighten the nuts to secure the base - Garmin Zumo 660 | Installation Instructions - Page 3
of your zūmo into the cradle. 2. Tilt the zūmo back until it snaps into place. Cradle Release button Power cable Remove Your zūmo from Either Mount 1. Press the button on the side of the mount to release the zūmo. 2. Lift out the zūmo. 3. Place the weather cap on the cradle (motorcycle mount only). - Garmin Zumo 660 | Installation Instructions - Page 4
cup mount on a motorcycle. 5. Snap the cradle onto the suction cup arm. 6. Fit the bottom of your zūmo into the cradle. 7. Tilt the zūmo back until it snaps into place. 8. Plug the other end of the automotive power cable into a power outlet. 9. If you are using a traffic receiver in Europe
-
1 -
2 -
3 -
4
 |
 |
zūmo 660 Installation Instructions
Mount Your zūmo on the Motorcyle
WARNING:
Incorrectly wiring the power cable with bare wire leads can result in
damage to the vehicle or the battery and can cause bodily injury. Garmin strongly
recommends having an experienced installer with the proper knowledge of electrical
systems install the unit.
See the
Important Safety and Product Information
guide in the product box for product warnings
and other important information.
Step 1: Connect Power to the Mount
Select a suitable and secure location to mount the zūmo on your motorcycle, based on
available power sources and safe cable routing.
Cradle
Headphone/audio out jack (3.5 mm)
Microphone jack (2.5 mm)
Mini-USB connector
(for traffic receiever)
Bare wires with
inline fuse for
power connection
Power cable
Step 2: Install the Handlebar Base
The zūmo includes parts for two handlebar installation solutions. Custom mounts can
require additional hardware (
www.ram-mount.com
).
A) To install the U-bolt and handlebar base:
1. Place the U-bolt around the handlebar, and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do not overtighten.
NOTE:
The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in.
Handlebar
base
Handlebar
U-bolt