Gateway 9715 Server Pedestal Conversion Kit
Gateway 9715 Manual
 |
View all Gateway 9715 manuals
Add to My Manuals
Save this manual to your list of manuals |
Gateway 9715 manual content summary:
- Gateway 9715 | Server Pedestal Conversion Kit - Page 1
as a rack system, disconnect the power cords and remove the slide rails, cable management arm, and local control panel. For instructions, see your server user guide. 2 Lay the server upside-down (fan side down) onto the floor or other strong and stable work surface. 3 Slide the outer cover onto the - Gateway 9715 | Server Pedestal Conversion Kit - Page 2
www.gateway.com 5 Align each caster assembly with its screw hole, then attach it using one Phillips screw per assembly. Caster assembly Phillips screw 6 To change the server's front bezel, remove all the Torx screws that secure the old bezel to the server, then remove the bezel. 7 Secure the new
-
1 -
2
 |
 |
1
Package contents
The pedestal conversion kit includes the following:
■
1 Outer cover
■
6 Phillips screws
■
4 Caster assemblies (includes mounting brackets and screws)
■
1 Pedestal face plate
■
6 Torx screws (2 extras)
Installing the pedestal mount
To install the pedestal mount:
1
If the server has already been set up as a rack system, disconnect the
power cords and remove the slide rails, cable management arm, and local
control panel. For instructions, see your server user guide.
2
Lay the server upside-down (fan side down) onto the floor or other strong
and stable work surface.
3
Slide the outer cover onto the bottom (the hot-swap drive side) of the
server.
4
Align the screw holes of the outer cover with those on the server, then
secure the outer cover in place with the six Phillips screws.
Phillips screws (6)
Outer cover
Installing the Pedestal Conversion Kit