Gateway NV-54 Gateway Quick Start Guide for Windows 7 - Page 52

RCA-RCA shielded Audio/Video Cables from Thomson KHC001M, KHC012M - ac adapter

Page 52 highlights

Gateway recommends that you add a ferrite core round clip to each cable connecting your Gateway computer to a hardware device that has not been delivered with your computer. ­ Ferrite reference: 28A-2029 from Steward (two loops) For Ethernet LAN cable, use FTP shielded cables only (cat ≥ 5). During product certification, Gateway used the following cable quality: ­ USB2.0 Certified Cables from Hama 46778 ­ IEEE1394 shielded FireWire from Hama 50011 ­ RCA-RCA shielded Audio/Video Cables from Thomson KHC001M, KHC012M, KHC028M ­ Stereo Jack shielded Audio cables from Hama 43330H, 42714H ­ Ethernet Shielded Cables Cat 5e from Hama 50030 Heat Build-up and Portable Computers The AC adapter and the underside of the computer can become hot after prolonged use. Sustained physical contact with either should be avoided. CHASSIS COVER REMOVAL AND REPLACEMENT Before removing the chassis cover to service or modify the equipment, you must disconnect all power and modem cords, and remove the battery. CAUTION: SOME COMPONENTS INSIDE THE COMPUTER CAN BECOME HOT AFTER PROLONGED USE. You then must close the chassis before you plug in and switch on the equipment. LASER COMPLIANCE STATEMENT The optical devices are tested and certified to be compliant with International Electrotechnical Commission IEC60825-1 and European EN60825-1 standards for Class 1 laser products. Class 1 laser products are not considered hazardous. The optical devices are designed such that there is never human access to laser radiation above a Class 1 level during normal operation or prescribed maintenance conditions. The optical devices installed in your computer are designed for use solely as components of such electronic product and therefore do not comply with the appropriate requirements of Code of Federal Regulation Sec. 1040.10 and Sec. 1040.11 for COMPLETE laser products. Because exposure to laser radiation is extremely hazardous, under no circumstances should the user attempt to disassemble the laser device. PACKAGING The packaging of this product is compliant with the European Environmental Directive 94/62/EC from December 20 th 1994 and its equivalent in the French Legislation by the Decree 98-638 from july 20 th 1998. COMPLIANT WITH RUSSIAN REGULATORY CERTIFICATION 52 - Quick Start & Troubleshooting Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

52 -
Quick Start & Troubleshooting Guide
Gateway recommends that you add a ferrite core round clip to each cable connecting your Gateway computer
to a hardware device that has not been delivered with your computer.
±
Ferrite reference: 28A-2029 from Steward (two loops)
For Ethernet LAN cable, use FTP shielded cables only (cat
5).
During product certification, Gateway used the following cable quality:
±
USB2.0 Certified Cables from Hama 46778
±
IEEE1394 shielded FireWire from Hama 50011
±
RCA-RCA shielded Audio/Video Cables from Thomson KHC001M, KHC012M, KHC028M
±
Stereo Jack shielded Audio cables from Hama 43330H, 42714H
±
Ethernet Shielded Cables Cat 5e from Hama 50030
Heat Build-up and Portable Computers
The AC adapter and the underside of the computer can become hot after prolonged use. Sustained physical
contact with either should be avoided.
C
HASSIS
C
OVER
R
EMOVAL
AND
R
EPLACEMENT
Before removing the chassis cover to service or modify the equipment, you must disconnect all power and
modem cords, and remove the battery.
CAUTION: SOME COMPONENTS INSIDE THE COMPUTER CAN BECOME HOT AFTER PROLONGED USE.
You then must close the chassis before you plug in and switch on the equipment.
L
ASER
C
OMPLIANCE
S
TATEMENT
The optical devices are tested and certified to be compliant with International Electrotechnical Commission
IEC60825-1 and European EN60825-1 standards for Class 1 laser products.
Class 1 laser products are not considered hazardous. The optical devices are designed such that there is never
human access to laser radiation above a Class 1 level during normal operation or prescribed maintenance
conditions.
The optical devices installed in your computer are designed for use solely as components of such electronic
product and therefore do not comply with the appropriate requirements of Code of Federal Regulation Sec.
1040.10 and Sec. 1040.11 for COMPLETE laser products.
Because exposure to laser radiation is extremely hazardous, under no circumstances should the user attempt to
disassemble the laser device.
P
ACKAGING
The packaging of this product is compliant with the European Environmental Directive 94/62/EC from December
20 th
1994 and its equivalent in the French Legislation by the Decree 98-638 from july 20 th 1998.
C
OMPLIANT
WITH
R
USSIAN
REGULATORY
CERTIFICATION