GE 51207 User Manual

GE 51207 - Smart Home Wireless Motion Sensor Alarm Manual

Get GE 51207 - Smart Home Wireless Motion Sensor Alarm PDF manuals and user guides
UPC - 043180506436
View all GE 51207 manuals
Add to My Manuals
Save this manual to your list of manuals

GE 51207 manual content summary:

  • GE 51207 | User Manual - Page 1
    Personal Security Motion Sensor with Remote User Manual Do not use in wet locations
  • GE 51207 | User Manual - Page 2
    Motion Sensing Alarm With Remote Control Wall Mount Indicator Light Keychain Remote Motion Sensing Alarm Alarm/Chime Switch Low Battery Indicator The Motion Sensing Alarm has a low battery indicator light. If the batteries need to be replaced, the indicator light will flash slowly. Average battery
  • GE 51207 | User Manual - Page 3
     INSTALLING BATTERIES The Remote Controlled Motion Sensing Alarm requires 3 AA Alkaline batteries (not included). Installing Batteries in the Alarm The battery compartment is located on the back of the unit. 1. Remove the battery compartment screw and slide off cover in the direction of the
  • GE 51207 | User Manual - Page 4
     located on the back of the remote control. 2. Insert a 2032 battery noting polarity inside the battery compartment. 3. Replace cover. Battery Compartments Learn Button Remote
  • GE 51207 | User Manual - Page 5
     LINKING THE REMOTE TO THE ALARM Make sure you have installed the batteries before proceeding. 1. Remove the battery compartment screw and slide off cover in the direction of the open arrow. Locate LEARN button. Battery Compartment Learn Learn Button 2. Press the LEARN button.
  • GE 51207 | User Manual - Page 6
    mode. NOTE: Additional remotes can be added to the system by following the same programming procedure. INSTALLATION The unit is designed to be wall mounted with the ball and socket mount (included). The ball and socket mount will provide the flexibility to aim the motion sensor in a particular
  • GE 51207 | User Manual - Page 7
     1. Choose your desired location, such as the corner of the room. This will provide maximum coverage. NOTE: The sensor has a 15-20 ft. detection zone, with approximate angles of 110˚ horizontal x 70˚ vertical. Recommended installation height is 6 to 8 feet. 20' 15' 110˚ 10' 5' Feet 6'-8'
  • GE 51207 | User Manual - Page 8
    the wall, slide insert bracket of mount into the back of the unit and lock in place. The mount will click when secured to the alarm. OPERATING IN THE ALARM MODE 1. Locate the ALARM/CHIME switch on the side of the remote. Chime Alarm 2. Slide switch to
  • GE 51207 | User Manual - Page 9
    will sound a short tone and a red light will flash. The alarm will activate in 30 seconds. The siren will sound for 30 seconds (unless disarmed by the remote) and then turn off. In 15 seconds the alarm will check for motion. If motion is detected, the siren will sound again. The cycle will repeat
  • GE 51207 | User Manual - Page 10
    When returning to the protected area, the unit will beep once if motion is sensed. 1. Point the remote control at the front of the alarm unit and press the DISARM button within 30 seconds to disarm the alarm. 2. If the remote control with the correct security code is not used within 30 seconds, the
  • GE 51207 | User Manual - Page 11
    The chime is used to notify you when motion is sensed in the area. 1. Locate ALARM/CHIME switch on the side of the remote. Chime Alarm 2. Slide switch to CHIME mode. ACTIVATING THE CHIME Activate the chime by pointing the remote control at the alarm and pressing the 'ARM' button. The chime will
  • GE 51207 | User Manual - Page 12
    and press and hold the ARM and DISARM buttons on the remote control for 2 seconds. To turn off the panic alarm, aim the remote at the front of the alarm and press the DISARM button. TESTING MOTION SENSOR OPERATION 1. Set remote to CHIME mode and press ARM button; the chime will sound once. 2. After
  • GE 51207 | User Manual - Page 13
    chemical agents as this may damage and discolor the unit. WARNING Limitations of Alarm Products This product should be tested periodically to make sure it is working maintenance; tampering; dead or improperly installed batteries; sensing limitations; component failures; receivers; for infrared
  • GE 51207 | User Manual - Page 14
    Warning • Remove batteries before storing the Alarm for extended periods • Batteries may leak harmful Service at 800-654-8483 between 7:30AM-5:00PM CST or via our website (www.jascoproducts.com) if the unit should prove defective within the warranty period. is a trademark of the General Electric
  • GE 51207 | User Manual - Page 15
    installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
Do not use in wet locations
Personal Security
Motion Sensor
with Remote
User Manual