GE 6155 Installation Instructions
GE 6155 - Security Sharpshooter PIR Sensor Manual
 |
UPC - 046188009565
View all GE 6155 manuals
Add to My Manuals
Save this manual to your list of manuals |
GE 6155 manual content summary:
- GE 6155 | Installation Instructions - Page 1
6150 Extended Temperature Series SharpShooter™ PIR Installation Instructions Models 6155XT, 6157XT Back case Swivel mounting bracket #8 x 3/4"(2cm) Masking kit included) Front cover Sliding LED cover Description The Sentrol 6150 Extended temperature series passive infrared detector is an advanced - GE 6155 | Installation Instructions - Page 2
Mounting With the Swivel Bracket The swivel bracket allows aiming and adjusting the unit for maximum detection and avoidance of false alarms. You can mount the unit with or without the swivel bracket. The swivel bracket’s snap-off tabs allow angle mounting, such as for hallway protection. Break the - GE 6155 | Installation Instructions - Page 3
the jumper as shown to select one or two zone detection. Zone Patterns Top View Standard Mfg.0128 Two Zone (4 pulses) SENTROL REMOVE FOR TEST 6155XT-N One Zone (2 pulses) Listed U 3 2 K 9 L Intrusion detection unit burglary 7-16VDC, 10mA (max) NC COM TMP TMP + - 2-Zone Detection - GE 6155 | Installation Instructions - Page 4
operation. 4. Slide the LED cover up to hide the LED, if desired. Troubleshooting with Test Mode The unit has a test mode to: • Verify the exact . Remember, there are two beams in each zone. Mfg.0128 Two Zone (4 pulses) SENTROL REMOVE FOR TEST 6155XT-N One Zone (2 pulses) Listed U 3 2 K 9 L
-
1 -
2 -
3 -
4
 |
 |
6150 Extended Temperature Series SharpShooter PIR
1
Hot or cold air directed
onto sensor
Pets
Intermittent
heat sources
Windows
Sunlight or
reflected sunlight
Do Not Block the Coverage Pattern
The unit requires a clear line of sight± Inform end-users not to
block the coverage pattern with inventory or furniture±
15
10
5
0
5
10
10
5
0
5
10
Standard lens
(Masking kit included)
Swivel mounting bracket
#8 x 3/4"(2cm) screw
for ball joint shoe
Front cover
Two #6 x 3/4"(2cm) screws for
mounting the bracket or case
(Two #6 wall anchors are
included for sheet rock mounting)
Mounting knockouts
Lens shield/circuit
board assembly
Back case
6150 Extended Temperature
Series SharpShooter
±
PIR
Installation Instructions
Models 6155XT,
6157XT
Sliding LED cover
Description
The Sentrol 6150 Extended temperature series passive infrared
detector is an advanced PIR detector that utilizes a dual pyroelec-
tric sensor with jumper-selectable one- or two-zone detection± It
also features a sequence processor that combines bi-directional
pulse counting and event verification± An opaque, off-white,
visible-light filtering fresnel lens focuses the infrared energy on the
pyroelectric sensor while reducing false alarms from stray light
sources± The unit features two interchangeable lenses: standard and
vertical barrier±
Mounting Location
Locate for Cross Traffic
For maximum detection, place the unit where intruders move
across
the beams, not toward the unit±
Avoid False Alarm Sources
For false-alarm-free operation, the unit should not ²see³ sources
of heat or cold±