GE GTDP400GMWS Quick Specs

GE GTDP400GMWS Manual

GE GTDP400GMWS manual content summary:

  • GE GTDP400GMWS | Quick Specs - Page 1
    -delay fuse is required. Gas Dryer Electric Rating: 120V, 60Hz, 6A Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas supply requires a conversion kit. Check installation instructions for correct kit and have a qualified gas technician install a conversion kit
  • GE GTDP400GMWS | Quick Specs - Page 2
    GE® 7.0 cu. ft. capacity DuraDrum,™ gas dryer with Sensor Dry™ For complete information, see installation instructions packed with your dryer. Ducting Materials: For best performance, this dryer with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers. Minimum Clearances
  • GE GTDP400GMWS | Quick Specs - Page 3
    GTDP400GM GE® 7.0 cu. ft. capacity DuraDrum,™ gas dryer with Sensor Dry™ Features and Benefits •  for more flexible installation • Interior dryer light - Convenient interior light helps you easily see clothes • Model GTDP400GMWS -White on white GTDP400EM_GM GTDX400EM_GM Specification Created
  • 1
  • 2
  • 3

For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
ge.com or call GE Answer Center
®
service,
800.626.2000.
370185
GTDP400GM
GE
®
7.0 cu. ft. capacity DuraDrum‚
gas dryer with Sensor Dry
36
42
27
2
3-1/2
2-1/2
25-1/2*
Side View
Rear View
8-1/2
28-1/4
23-1/2
11-1/2
*24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of endcaps.
5
Back View
Power
Cord Hole
4-1/2
Power Cord Locations
Exhaust Option:
When viewed from the front
of the unit, exhaust 3-way via rear, left and
bottom. Dryer is shipped exhausted to the
rear. Alternate exhausting knockouts are
supplied.
Gas:
An individual, properly-grounded
branch circuit, with a three-prong grounding-
type receptacle, protected by a 15 or 20
amp circuit breaker or a time-delay fuse is
required.
Gas Dryer Electric Rating:
120V, 60Hz, 6A
Gas (BTU/HR):
22,000. Factory-equipped for
natural gas. Tested for LP gas. LP gas supply
requires a conversion kit. Check installation
instructions for correct kit and have a
qualified gas technician install a conversion
kit. See dryer ducting information for proper
installation.
Note:
Dryer wall outlet must be located within
36" of service cord entry and accessible when
dryer is mounted in position.
Installation Information:
For complete
information, see installation instructions
packed with your dryer.
Dimensions and Installation Information (in inches)
Specification Created 7/10