GE GTUP240EMWW Quick Specs

GE GTUP240EMWW Manual

GE GTUP240EMWW manual content summary:

  • GE GTUP240EMWW | Quick Specs - Page 1
    /240GM GE® 24" Unitized Spacemaker® Washer and Dryer Dimensions and Installation Information (in inches) Electrical Requirements: GTUP240EM Electric Dryer - This appliance should be connected to an individual, properly-grounded branch circuit with 120/240V single-phase 60 Hz electrical service and
  • GE GTUP240EMWW | Quick Specs - Page 2
    National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers. For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Minimum Clearances other than Alcove or Closet Installation: • Minimum
  • GE GTUP240EMWW | Quick Specs - Page 3
    GTUP240EM/240GM GE® 24" Unitized Spacemaker® Washer and Dryer Features and Benefits • 2.2 cu. ft. capacity washer • 4.4 cu. ft. capacity dryer • 3 wash/spin speed combinations - Speeds are matched to fabric type for great clothes care • 9 wash cycles - Cycles are designed to specifically handle
  • 1
  • 2
  • 3

Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
®
service, 800.626.2000.
360329
GTUP240EM/240GM
GE
®
24" Unitized Spacemaker
®
Washer and Dryer
Listed by
Underwriters
Laboratories
Specification Revised 2/11
Electrical Requirements:
GTUP240EM Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V single-phase
60 Hz electrical service and should be protected by 30-amp time-delay
fuses or circuit breakers. This appliance is manufactured with neutral
connected to the frame. Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
GTUP240GM Gas Dryer – This appliance should be connected to an
individual branch circuit with a three-prong grounding-type receptacle
and 120-volt single-phase 60 Hz electrical service and should be
protected by 15- or 20-amp time-delay fuses or circuit breakers. This
appliance is equipped with a 6-foot long flexible U.L. listed 20-amp power
cord to match a 15-amp receptacle.
Gas Rated
input 10,500 BTU/HR. Factory equipped for natural gas. Tested
for LP gas.
Dryers
must
be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with
the product.
74-1/2
32-7/10
23-3/4
27-1/2
27-1/4
Floor line
Distance
from vent
to back 4-1/2"
26-3/5
Water
inlet-
cold
1" For leveling legs
32-7/10
27-1/4
23-3/4
27-1/2
37
74-1/2
1/2
21-5/16
8
Drain
19-
11/100