GE GTUP270EMWW Quick Specs

GE GTUP270EMWW Manual

GE GTUP270EMWW manual content summary:

  • GE GTUP270EMWW | Quick Specs - Page 1
    GE® 27" Unitized Spacemaker® Washer and Dryer Dimensions and Installation Information (in inches) Electrical Requirements: GTUP270EM Electric Dryer - This appliance should be connected to an individual, properly-grounded branch circuit with 120/240V or 120/208V single-phase 60 Hz electrical service
  • GE GTUP270EMWW | Quick Specs - Page 2
    GTUP270EM/270GM GE® 27" Unitized Spacemaker® Washer and Dryer Dimensions and Installation Information (in inches) GTUP270EM/GM DRYER EXHAUST LENGTH RECOMMENDED MAXIMUM LENGTH Exhaust Hood Types Recommended Use only for short run installations 4" DIA. 4" DIA. 4" DIA. No. of 90º Elbows 0 1 2
  • GE GTUP270EMWW | Quick Specs - Page 3
    (washer) - Simplify cycle selection • Cycle status lights - Provide accurate cycle times • Rotary-electromechanical controls (dryer) - Allow fast, easy cycle selection • Model GTUP270EMWW - White on white (Electric) • Model GTUP270GMWW - White on white (Gas) GTUP270EM Specification Revised
  • 1
  • 2
  • 3

Dimensions and Installation Information (in inches)
For answers to your Monogram,
®
GE Profile
or
GE
®
appliance questions, visit our website at
geappliances.com or call GE Answer Center
®
service, 800.626.2000.
360328
GTUP270EM/270GM
GE
®
27" Unitized Spacemaker
®
Washer and Dryer
Listed by
Underwriters
Laboratories
Specification Revised 2/11
Electrical Requirements:
GTUP270EM Electric Dryer – This appliance should be connected to an
individual, properly-grounded branch circuit with 120/240V or 120/208V
single-phase 60 Hz electrical service and should be protected by
30-amp time-delay fuses or circuit breakers KW Rating per voltage
(240/208). This appliance is manufactured with neutral connected to the
frame. Power cord should be purchased separately.
Note:
These appliances are not approved for 120-volt operation.
Gas Requirements:
GTUP270GM Gas Dryer – This appliance should be connected to an
individual branch circuit with 120-volt single-phase 60 Hz electrical service
and should be protected by 20-amp time-day fuses or circuit breakers.
This appliance is equipped with a 4-foot long flexible U.S. listed 20-amp
power cord to match a 20-amp receptacle.
Note:
Gas Rated input 20,000 BTU/HR. Factory equipped for natural gas. Tested
for LP gas.
LP gas supply requires a conversion kit.
Have a qualified gas
technician install a conversion kit before use.
Dryers
must
be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with
the product.
75-1/2
33-18/25
26-4/5
30
30-17/20
Floor line
Distance
from vent
to back 4-1/2"
27-3/5
Water
inlet-
cold
1" For leveling legs
33-18/25
30-17/20
26-4/5
30
37
75-1/2
1/2
21-5/16
8
Drain
20-
7/40