GE JVM2052DNWW Installation Instructions
GE JVM2052DNWW - Spacemaker Series Microwave Oven Manual
 |
UPC - 084691188070
View all GE JVM2052DNWW manuals
Add to My Manuals
Save this manual to your list of manuals |
GE JVM2052DNWW manual content summary:
- GE JVM2052DNWW | Installation Instructions - Page 1
Installation Instructions Above the Cooktop Oven Model JVM2052 Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - - GE JVM2052DNWW | Installation Instructions - Page 2
Installation Instructions CONTENTS General information Important Safety Instructions 3 Electrical Requirements 3 Hood Exhaust 4-5 Damage - Shipment/Installation 6 Parts Included 6 Tools You Will Need 7 Mounting Space 7 Step-by-step installation guide Placement of Mounting Plate 8-10 - GE JVM2052DNWW | Installation Instructions - Page 3
damage, you will need two people to install this microwave oven. Where a standard two-prong wall receptacle is encountered, it must be replaced with a properly grounded three-prong wall receptacle, installed by a qualified electrician. WARNING: Risk of Electric Shock. Can cause injury or death: DO - GE JVM2052DNWW | Installation Instructions - Page 4
Installation Instructions HOOD EXHAUST NOTE: Read these next two pages only page 6. OUTSIDE TOP EXHAUST (EXAMPLE ONLY) The following chart describes an example of one possible ductwork installation. DUCT PIECES EQUIVALENT LENGTH x NUMBER USED EQUIVALENT = LENGTH Roof Cap 24 Ft. x (1) = - GE JVM2052DNWW | Installation Instructions - Page 5
Installation Instructions NOTE: If you need to install ducts, note that the total duct length of 31⁄4" x 10" HOOD EXHAUST DUCT. Read the following carefully. NOTE: It is important that venting be installed using the most direct route and with as few elbows as possible. This ensures clear - GE JVM2052DNWW | Installation Instructions - Page 6
. weight requirement . PARTS INCLUDED ADDITIONAL PARTS PART QUANTITY Upper Cabinet 1 Template Rear Wall 1 Template (3 pieces mounting plate only) Installation 1 Instructions Exhaust 1 Adapter Damper 1 Power Cord 1 Clamp Bushing (for the cord hole in a metal upper cabinet) 6 - GE JVM2052DNWW | Installation Instructions - Page 7
30", a Filler Panel Kit may be used to fill in the gap between the oven and the cabinets. Your Owner's Manual contains the kit number for your model. • This oven is for installation over ranges up to 36" wide. • If you are going to vent your oven to the outside, see Hood Exhaust Section - GE JVM2052DNWW | Installation Instructions - Page 8
1 PLACEMENT OF THE MOUNTING PLATE A REMOVING THE MICROWAVE OVEN FROM THE CARTON/ REMOVING THE MOUNTING PLATE 1 Remove the installation instructions, filters, glass tray and the small hardware bag. Do not remove the Styrofoam protecting the front of the oven. 2 Fold back all 4 carton flaps - GE JVM2052DNWW | Installation Instructions - Page 9
Installation Instructions C DETERMINING WALL PLATE LOCATION UNDER YOUR CABINET Plate position - have decorative trim that interferes with the microwave oven installation. Remove the decorative trim to install the microwave oven properly and to make it level. THE MICROWAVE OVEN MUST BE LEVEL. Use a - GE JVM2052DNWW | Installation Instructions - Page 10
Installation Instructions D ALIGNING THE WALL PLATE Hole A Hole C Centerline Notches Draw a in a stud to support the weight of the microwave oven. Set the mounting plate aside. WARNING: Risk of Electric Shock. Can cause injury or death. Take care to not drill into electrical wiring inside walls - GE JVM2052DNWW | Installation Instructions - Page 11
Exhaust (Horizontal Duct) C. Recirculating (Non-Vented Ductless) NOTE: This microwave oven is shipped assembled for Outside Top Exhaust (except for non-vented models). Select the type of ventilation required for your installation and proceed to that section. A OUTSIDE TOP EXHAUST (VERTICAL DUCT - GE JVM2052DNWW | Installation Instructions - Page 12
Installation Instructions A OUTSIDE TOP EXHAUST (Vertical Duct) INSTALLATION OVERVIEW A1. Attach Mounting Plate to Wall A2. Prepare Top Cabinet A3. Attach Exhaust Damper A4. Mount Microwave Oven A1 ATTACH THE MOUNTING PLATE TO THE WALL To use toggle bolts: Mounting Plate Spacing for Toggles More - GE JVM2052DNWW | Installation Instructions - Page 13
oven) or property damage, you will need two people to install this microwave oven. IMPORTANT: Do not grip or use handle during installation. WARNING: Risk of Electric Shock. Can cause injury or death: If installing unit with metal countertops, cover the edge of the power supply cord hole with - GE JVM2052DNWW | Installation Instructions - Page 14
Installation Instructions A4 MOUNT THE MICROWAVE OVEN (cont .) Damper 4 Use the power supply cord clamp to bundle the power supply cord. Install the power supply cord clamp, using a screw as shown, to the inside of the cabinet. Cabinet Front Cabinet Bottom Shelf Filler Block Equivalent to Depth - GE JVM2052DNWW | Installation Instructions - Page 15
Installation Instructions B OUTSIDE BACK EXHAUST (Horizontal Duct) INSTALLATION OVERVIEW B1. Prepare Rear Wall B2. Attach Mounting Plate to Wall B3. Prepare Top Cabinet B4. Adjust Blower B5. Mount the Microwave Oven B1 PREPARE THE REAR WALL FOR OUTSIDE BACK EXHAUST You need to cut an opening in the - GE JVM2052DNWW | Installation Instructions - Page 16
Installation Instructions B2 ATTACH THE MOUNTING PLATE TO THE WALL B3 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws and a hole large enough for the power cord to fit through. Attach the plate to the wall using toggle bolts. At least one - GE JVM2052DNWW | Installation Instructions - Page 17
Installation Instructions B4 ADAPT MICROWAVE Risk of electric shock can cause guides at the top center of the back of the oven. Adapter Back of Microwave Oven Guide Guide Locking Tabs Push in securely until it is in the lower locking tabs. Take care to ensure that the damper hinge is installed - GE JVM2052DNWW | Installation Instructions - Page 18
oven) or property damage, you will need two people to install this microwave oven. IMPORTANT: Do not grip or use handle during installation. WARNING: Risk of Electric Shock. Can cause injury or death: If installing unit with metal countertops, cover the edge of the power supply cord hole with - GE JVM2052DNWW | Installation Instructions - Page 19
Installation Instructions C RECIRCULATING (Non-Vented Ductless) INSTALLATION OVERVIEW C1. Attach Mounting Plate to Wall C2. Prepare Top Cabinet C3. Adjust Blower C4. Mount the Microwave Oven C5. Install support screws and a hole large enough for the power cord to fit through. • Read the instructions - GE JVM2052DNWW | Installation Instructions - Page 20
Installation Instructions C3 ADAPT MICROWAVE OVEN BLOWER FOR RECIRCULATION 1 Remove and save 3 blower plate grooves of the motor frame. 4 Place the blower unit back into the opening. WARNING: Risk of electric shock can cause injury or death. Do not pull or stretch the blower unit wiring. Make sure - GE JVM2052DNWW | Installation Instructions - Page 21
oven) or property damage, you will need two people to install this microwave oven. IMPORTANT: Do not grip or use handle during installation. WARNING: Risk of Electric Shock. Can cause injury or death: If installing unit with metal countertops, cover the edge of the power supply cord hole with - GE JVM2052DNWW | Installation Instructions - Page 22
Installation Instructions C5 INSTALLING THE CHARCOAL FILTER 1 Remove 2 screws on the top front of the grille using a Phillips screwdriver. 2 Open the door. 3 Remove the grille, pulling it straight off. Charcoal Filter 4 Install the charcoal filter. When properly installed, the wire mesh of the - GE JVM2052DNWW | Installation Instructions - Page 23
the Owner's Manual. 2 Remove all packing material from the microwave oven. 3 Install turntable and ring in cavity. 4 Replace house fuse or turn breaker back on. 7 KEEP INSTALLATION INSTRUCTIONS FOR THE LOCAL INSPECTOR'S USE. 5 Plug power cord into a dedicated 15- to 20-amp electrical outlet - GE JVM2052DNWW | Installation Instructions - Page 24
Printed in China
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
 |
 |
Questions? Call 800.GE.CARES (800.432.2737)
or
Visit our Website at:
GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Installation
Above the
Instructions
Cooktop Oven
Model JVM2052
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer
–
Be sure to leave these
instructions with the Consumer.
BEFORE YOU BEGIN
•
Note to Consumer –
Keep these instructions
for future reference.
•
Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty.
49-40587-1
MFL57007101
07-09 JR