GE JVM6175SKSS Quick Specs
GE JVM6175SKSS Manual
View all GE JVM6175SKSS manuals
Add to My Manuals
Save this manual to your list of manuals |
GE JVM6175SKSS manual content summary:
- GE JVM6175SKSS | Quick Specs - Page 1
(non-vented ductless - see Filter Kit drawing) INSTALLATION INFORMATION: This information is 29-7/8" not intended to be used for installing unit described. Before installing, consult installation instructions packed with product/kit for current dimensional data. 30" MIN. width required 13 - GE JVM6175SKSS | Quick Specs - Page 2
width to provide a custom built-in appearance. For installation between cabinets only; not for end-of-cabinet installation. Each kit contains two 3"-wide filler panels. Filter Kit JX81J- Recirculating Charcoal Filter Kit To be used when the microwave oven cannot be vented to the outside. DUCT - GE JVM6175SKSS | Quick Specs - Page 3
charcoal filter needs to be replaced Recessed turntable with on/off - Controls turntable operation Sensor cooking controls - Automatically adjusts time and power for delicious cooking results Model JVM6175SKSS - Stainless steel Model JVM6175EKES - Slate JVM6175SK_EK 6:30PM Sensor Microwave
Listed by
Underwriters
Laboratories
JVM6175SK/EK
GE Appliances 1.7 cu. ft. Over-the-Range Sensor Microwave Oven
Specification Created 2/16
105°
Door open
(without obstruction)
22-7/8
"
29-7/8"
16-1/2"
(rear)
15"
15-7/8"
13"
MAX.
12"
MIN.
66"
MIN.
Mounting
height from
floor
Minimum distance from
door hinge side to
adjacent wall should
equal
1/2"
.
30"
MIN.
width
required
Exhaust outlet
connects to
3-1/4"x10"
duct
DIMENSIONS AND INSTALLATION INFORMATION (IN INCHES)
For answers to your Monogram, GE Café
™
Series, GE Profile
™
Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center
®
Service, 800.626.2000.
NOTE:
Requires 120V grounded outlet. Electrical receptacle
must be located in cabinet above microwave oven. No
additional wiring, venting or cabinet rebuilding necessary in
many cases. Complete detailed, easy-to-follow installation
instructions and convenient full-size templates are packed
with the microwave oven.
IMPORTANT INFORMATION:
When installing the
microwave oven over a range, allow minimum of 2" from
bottom of microwave oven to top of range backguard to allow
for removal of light covers.
VENTILATION OPTIONS:
The microwave ovens are
designed for adaptation to the following three types of
ventilation:
-Outside exhaust (vertical – as shown)
-Outside exhaust (horizontal)
-Recirculating (non-vented ductless – see Filter Kit drawing)
INSTALLATION INFORMATION:
This information is
not intended to be used for installing unit described. Before
installing, consult installation instructions packed with
product/kit for current dimensional data.