GE PDW7980PSS Installation Instructions

GE PDW7980PSS - 6 LEVEL 12 TOUCHPADS CONTOCONTOUR DOOR 5 Manual

GE PDW7980PSS manual content summary:

  • GE PDW7980PSS | Installation Instructions - Page 1
    /_ ¢,* i¢_¸ _._ Appliances i< i i,3Lft_LIlL, nstallation instructions Built-In Dishwasher If you have questions, call 800.GE.CARES 1800.432.2737} or visit our website at: www.ge.com BEFORE YOU BEGIN Read these instructions completely and carefully. ,,,AP,,O_iRTANT - Observeallgovernincgodesand
  • GE PDW7980PSS | Installation Instructions - Page 2
    Installation Preparation PARTS SUPPLIED IN INSTALLATION PACKAGE: [] Two #8-18 × 5/8" Phillips special head screws, to secure dishwasher to underside of countertop -Off Valve Thread Seal Tape Wire Nuts 13) Waste Tee Air Gap Electrical Cable Hot Water Line !or Power Cord, if applicable) ©@ @
  • GE PDW7980PSS | Installation Instructions - Page 3
    , sides and back, and must not support and part of the enclosure. I CLEARANCES: When installed into a corner, atlow 2" min. clearance between dishwasher and adjacent cabinet, wall or other appliances. Allow 28_3/8" min. clearance from the fron; of tile dishwasher for door opening. Figure B Figure
  • GE PDW7980PSS | Installation Instructions - Page 4
    electrical supply does not meet the above requirements, call a licensed electrician before proceeding. Grounding Instructions-Cable Direct This appliance through a separate hole. Electrical Connection to Dishwasher Electrical connection is on the right front of dishwasher. • For cable direct
  • GE PDW7980PSS | Installation Instructions - Page 5
    pass through the some hole as the electrical cable and drain hose. Or, cut on additional 1-1/2" diameter hole to accommodate the water fine. If power cord with plug is used, water line must not pass through power cord hole. STEP 2-CHECK DOOR BALANCE o With dishwasher on the wood skid, check the
  • GE PDW7980PSS | Installation Instructions - Page 6
    with the National Electrical Code, Section 422 and/or loca! codes and ordinances, Maximum power cord length is 6 feet. Power Cord Kit WX09×70910, available for purchase from an authorized GE Appliance Dealer, meets these requirements. Junction Box Cover Wires Power Cord 0 Dishwasher Wires Figure
  • GE PDW7980PSS | Installation Instructions - Page 7
    at o _ime, Figure N House Wiring \ STEP 9-INSERT DRAIN HOSE THROUGH CABINET • Position dishwasher in front of cabinet opening. Insert drain hose into the hole in cabinet side. tf e power cord is used, guide the end through o separate hole. Drain -Hose Length 10' Blanket Figure N (If Power
  • GE PDW7980PSS | Installation Instructions - Page 8
    Instructions . Order part GPF65 from gour authorized GE Appliance Dealer. • Fasten the left-hand bracket to the left side of the dishwasher frame. service charges. Carefullg open and close the door to ensure the door panel is not catching or rubbing on the cabinet frame. STEP 14-LEVEL DISHWASHER
  • GE PDW7980PSS | Installation Instructions - Page 9
    Installation Instructions STEP 15-POSITION DISHWASHER, SECURE TO COUNTERTOP OR CABINET In this step gou will need the 2 Phillips special head screws from the screw kit set aside in Step 1. The dishwasher must be secured to the countertop or the cabinet sides. When the underside of the countertop
  • GE PDW7980PSS | Installation Instructions - Page 10
    instructions 120" 110feet} to timefactorg installed hose. Use 5/8" or 7/8" inside diameter hose and o coupler to connect the two hose ends. Secure Avoid unnecessarg service coil charges. Prior to connecting drain hose be sure excess hose is not trapped, kinked or crushed by the dishwasher. Pull
  • GE PDW7980PSS | Installation Instructions - Page 11
    19-PRETEST CHECK LIST Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty. [] Check to be are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise. [] Turn on the sink hot water
  • GE PDW7980PSS | Installation Instructions - Page 12
    are made. See Steps 7 and !7, [] Open dishwasher door and make sure most of the water has drained Instructions and product samples and/or coupons with the consumer. SPECIFICATIONSSUBJECT TO CHANGE WITHOUT NOTICE GE Consumer & Industrial General Electric Company Louisville, Kentuckg z40225 ge
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

/_
¢,*
i¢_¸
_._
Appliances
i< i i,3Lft_Ll
IL,
nstallation
instructions
Built-In Dishwasher
If you have questions,
call 800.GE.CARES 1800.432.2737} or visit
our website
at: www.ge.com
BEFORE YOU BEGIN
Read these instructions
completely
and
carefully.
IM
PORTANT.The
dishwasherMUST be installed
to oliow for future removal
from
the enclosure
if service is
required.
,,,A,,_i
PORTANT
-
Observeallgoverning
codesand
ordinances.
• Note to Installer
- Be sure to leave these instructions
for the
consumer's
and local inspector's
use,
• Note to Consumer
- Keep these instructions
with
gour
Owner's
Manuo! for future
reference.
• Skill Level - Installation
of this dishwasher
requires
basic mechanical,
electrical
and plumbing
skills. Proper
installation
is the responsibility
of the
installer.
Product
failui;e
due to improper
installation
is not covered
under
the GE Appliance
warrontg,
See warrantg
information.
• Completion
Time - 2 to 3 Hours,
New installations
require
more time
than replacement
installations.
If gOu received o damaged
dishwasher,
gou should
immediately
contact
gout dealer or builder.
Optional Accessories
-
See the 0wner!s Manual for available
custom panel kits,
FOR YOUR SAFETY
Read and observe
all CAUTIONS and WARNINGS shown
throughout
these
instructions,
While
performing
installations
described
in this
booklet,
gloves, safetg
glasses
or goggles
should
be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
GSD6000
Series
PDW7000
Series
imagination at work