GE PEB7227SLSS Installation Instructions

GE PEB7227SLSS Manual

Get GE PEB7227SLSS PDF manuals and user guides View all GE PEB7227SLSS manuals
Add to My Manuals
Save this manual to your list of manuals

GE PEB7227SLSS manual content summary:

  • GE PEB7227SLSS | Installation Instructions - Page 1
    Installation Built-In Trim Kits Instructions Questions? Call GE Answer Center at 800.626.2000 or Visit our Website at: www.GEAppliances.com MODELS 30" Profile Kit: JX7230DLWW, JX7230DLBB, JX7230ELES, JX7230SLSS, JX7230BLTS 27" Profile Kit: JX7227DLWW, JX7227DLBB, JX7227ELES, JX7227SLSS, JX7227BLTS
  • GE PEB7227SLSS | Installation Instructions - Page 2
    Depth 27" Models: 9»16"overlap 30" Models: 21»8" overlap Height Width 1" Clearance beyond Trim Frame (on all sides) 1"overlap 3" min. CAUTION This trim kit uses air flow from the top, bottom and sides of the trim frame. Blocking the air flow can cause the microwave to function improperly
  • GE PEB7227SLSS | Installation Instructions - Page 3
    , two screws for each bracket. Short Screws 4 INSTALL THE RAILS Remove everything out of the microwave oven, including packing, Owner's Manuals, turntable and turntable support. A protective film has been applied to some microwave oven and trim kits. If applied, remove the film. Turn over the
  • GE PEB7227SLSS | Installation Instructions - Page 4
    ANY LOOSE ITEMS Your trim kit is now fully installed. Replace any loose items that were removed from the inside of the microwave oven. Save or discard the extra screws. Do not place them in the microwave oven. Keep these installation instructions for future reference. Replace house fuse or close
  • GE PEB7227SLSS | Installation Instructions - Page 5
    GE comunicándose al 800.626.2000 o visite nuestro sitio web en: www.geappliances.com MODELOS Kit Profile de 30": JX7230DLWW, JX7230DLBB, JX7230ELES, JX7230SLSS, JX7230BLTS Kit Profile Before beginning the installation, switch power off at service panel and lock the service disconnecting means to
  • GE PEB7227SLSS | Installation Instructions - Page 6
    electricista calificado o al personal del servicio técnico que instale un tomacorriente cerca del electrodoméstico. REQUISITOS ELÉ (en todos los lados) Mín. GH´ PRECAUCIÓN Este kit ajustable usa el flujo de aire desde la parte superior, inferior y los costados de la estructura ajustable.
  • GE PEB7227SLSS | Installation Instructions - Page 7
    Instale el Soporte Superior sobre la parte superior del gabinete. Centre el Soporte Superior en la parte del horno microondas, incluyendo el embalaje, Manuales del Propietario, el plato giratorio y película protectora en algunos hornos microondas y kits con terminaciones. Si cuenta con la misma,
  • GE PEB7227SLSS | Installation Instructions - Page 8
    Instrucciones de Instalación 5 INSTALE EL HORNO MICROONDAS Enchufe el cable de corriente en el tomacorriente dos en la parte inferior interna). Vuelva a insertar las tapas de los tornillos en los agujeros y empuje hacia adelante de manera firme. 9 REEMPLACE CUALQUIER ÍTEM FLOJO Su kit ajustable se
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
Part
Quantity
Trim Frame
1
Screw Covers
4
Base Pan
1
Upper Bracket
1
Rail
2
Bottom
Bracket
2
Phillips Round-
Head Screws
24
(19 required
for installation)
Phillips Round-
Head Flat-
tipped Screws
6
(4 required for
installation)
PARTS INCLUDED
Questions?
Call GE Answer Center at 800.626.2000
or
Visit our Website at:
www.GEAppliances.com
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
.
Installation
Built-In Trim Kits
Instructions
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT –
Save these
instructions for local inspector’s use.
•
IMPORTANT –
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these instructions
for future reference.
•
For easier installation and personal safety, we
recommend that two people install this microwave oven.
•
Unplug the microwave oven before attempting
installation of this kit.
•
Skill level
– Installation of this appliance requires
basic mechanical and electrical skills.
•
Completion time
– 1-3 hours
•
Proper installation is the responsibility of the installer.
•
Product failure due to improper installation is not
covered under the Warranty.
•
This kit and microwave are approved for installation
alone or above any single electric wall oven. Do not
mount adjacent (within 2 feet) to any range, cooktop,
gas oven, or other microwave.
TOOLS YOU WILL NEED
#2 Phillips
screwdriver
Pencil
Tape measure
Level
Small flathead
screwdriver
Drill with
7
64
” bit or #35
1
FOR YOUR SAFETY
WARNING
Before beginning the installation,
switch power off at service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to
the service panel.
WARNING
This oven must be plugged into a
properly grounded 3-hole, 120 volt receptacle as
required by the National Electric Code.
MODELS
30” Profile Kit:
JX7230DLWW, JX7230DLBB,
JX7230ELES, JX7230SLSS, JX7230BLTS
27” Profile Kit:
JX7227DLWW, JX7227DLBB,
JX7227ELES, JX7227SLSS, JX7227BLTS
Monogram Kit:
ZX2130SLSS, ZX2127SLSS