GE GTWN7450DWW Use and Care Manual - Page 6

Operating instructions. F Cycle Options Delay Wash When the Delay Wash button is repeatedly pressed, the delay time is set from 1 (01H) to 9 (09H) hours and back to clear (00H) hours. If you press and hold the Delay Wash button for 3 seconds, it will immediately reset. Fabric Softener Set this option to provide a deep rinse or when manually adding fabric softener to the rinse cycle. NOTE: This option is not allowed for some cycles. When allowed, it may change other settings (e.g. Spin may go to a higher setting) to maximize performance. NOTE: Do not use fabric softener dispensing balls with this washer. They do not work correctly in high efficiency washers. eWash When the eWash button is pressed, the cycle changes to its most energy efficient settings and all of the eMonitor lights will light to indicate that the most efficient settings are on. If you change settings, the eWash light will go off and the number of eMonitor lights will decrease (or increase) to indicate decreased (or increased) energy efficiency settings. G Additional Options Soak This option begins with a brief agitation, soaks for a specified period of time, then moves through the rest of the cycle automatically. Repeated pressing of the Soak button will add 15, then 30 and then return back to 0 soak minutes. Extra Rinse When you use extra detergent or bleach to clean heavily soiled clothes, use the Extra Rinse option to better remove additional residues. NOTE: This option is not allowed for some cycles. Control Lock You can lock the controls to prevent any selections from being made. Or you can lock the controls after you have started a cycle. Children cannot accidentally start the washer by touching buttons with this option selected. 7RORFNWKHZDVKHUFRQWUROV press and hold both the Soak and Extra Rinse buttons for 3 seconds. The control lock icon will light up when it is on. 7RXQORFNWKHZDVKHUFRQWUROV press and hold both the Soak and Extra Rinse buttons for 3 seconds. NOTE: The Power button can still be used when the machine is locked. Signal Select for an end of cycle signal. Automatic Load Sensing This provides the correct amount of water suited to the size and type of load placed in the unit. The washer will not fill with water during automatic load sensing if the lid is open. When the lid is closed the machine is able to begin filling with water in order to sense the load size. NOTE: This is a high efficiency washing machine with Infusor™ wash action. This system requires less water while providing effective cleaning action. You may notice that the water level is lower than on your previous washer. This is normal for an Infusor™-equipped washer. Average Small Load Average Medium Load Average Large Load Clothes Level Water Level Clothes Level Water Level Clothes Level Water Level 6