GE PFSS6PKXSS Use and Care Manual - Page 42
Not cooling. OFF/OFF - problems
UPC - 084691172420
View all GE PFSS6PKXSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Operating Instructions Safety Instructions Installation Instructions Before you call for service... Troubleshooting Tips Problem Water filter indicator light changed color Possible Causes This is normal. What To Do • The water filter indicator light shows the following: Green = Good Orange = Change soon Red = Change immediately • See About the water filter for more information. Water filter indicator light Water filter indicator must remains red even after be reset. replacing the water filter Non-LCD models: • Press and hold the ICE & WATER pad for 3 seconds. See About the water filter for more information. LCD models: • On the LCD screen, select SETTING, then WATER FILTER. Select REPLACE and follow the instructions given. Water filter indicator light is not lit This is normal. This light will turn orange to tell you that you need to replace the filter soon. The filter cartridge should be replaced when the replacement indicator light turns red. • See About the water filter for more information. Handle is loose / handle Handle needs adjusting. has a gap • See Attach the Fresh Food handle and Attach the Freezer handle sections for detailed instructions. Refrigerator beeping This is the door alarm. • Close door. Control setting is not lit (non-LCD models) On some models, the light • If the control settings do not light up, check to see if bulbs at the top of the refrigerator the light bulbs are burned out, and replace if necessary. compartment light up the temperature control settings. LCD screen freezes (LCD models) LCD screen needs to be reset. • Reset the LCD screen by inserting a paper clip into the small hole next to the SD card slot under the front edge of the dispenser opening (see Screen Functions: Photos for location). Not cooling. OF/OF appears in the display The cooling system is off. Non-LCD models: • Press and hold the ADJUST FREEZER and ENERGY SAVER pads at the same time for 3 seconds. You will hear a beep and the OF/OF will disappear. You can now adjust the temperature. Please allow 24 hours for the unit to cool to your set temperature. Not cooling. OFF/OFF appears in the display The cooling system is off. LCD models: • On the LCD screen, select SETTING, SYSTEM and then COOLING SYSTEM until a check mark appears beside COOLING SYSTEM. Select HOME. You can now adjust the temperature. Please allow 24 hours for the unit to cool to your set temperature. Consumer Support Troubleshooting Tips 42