Genie ChainLift 800 Owner's Manual - Page 24
Remote Control, Light Bulb/lens Installation
View all Genie ChainLift 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
8 REMOTE CONTROL BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION 1. Battery replacement. • To open, gently push straight out on battery cover lock tab as shown. (Fig. 8-1). • Slide open battery cover. - Remove old battery. • Make sure new battery is facing proper direction (Match battery polarity with symbols inside battery housing) (Fig. 8-2). - Recommended replacement battery type: Alkaline A23, 12 volt. NOTE: Batteries differ in care and maintenance. Follow the manufacturer's directions for battery maintenance, replacement, and use. • Slip new battery into place. - Slide battery cover until it clicks shut. • Operate remote to make sure it is working properly. (No re-programming is needed.) 2. Visor clip. (The visor clip may come already installed.)You will have to install the visor clip if you choose to attach your remote to the car visor. • Slide visor clip into back of remote control. - It will snap into place (Fig. 8-3). Slide out FIG. 8-1 Open battery cover. - and + polarity marks FIG. 8-2 Match battery polarity. FIG. 8-3 Attach visor clip. 9 LIGHT BULB/LENS INSTALLATION WARNING For added safety and protection please unplug opener before installing light bulb. NOTE: For lens covers locate Box 4. 1. Light bulb. • Recommendations. - Do NOT use a short neck bulb. - Light bulbs should be no more than 60 Watts. - Use a heavy duty service bulb for longer life. • Screw 1 bulb into each socket. 2. Lens. • Select a white (lamp) cover. • On the power head end nearest the garage door, line up lamp lens tabs on power head with corresponding slots in lens (Fig. 9-1). • Slide lens onto power head. Make sure the tabs are fully engaged into lens slots (Fig. 9-2). • Repeat for rear lens on power head. • Plug power cord back into electrical outlet. • Test lamp operation. Light bulb socket Lens tabs Light bulb socket FIG. 9-1 Slide each lens onto motor cover. FIG. 9-2 Fasten lens. 24 PN# 37026500123 05/15/2009