Genie ChainLift 800 Owner's Manual - Page 25

IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of severe injury or death: 1. READ AND FOLLOW ALL INSTRUCTIONS. 2. Never let children operate or play with the door controls. Keep the remote control away from children. 3. Always keep the moving door in sight and away from people and objects until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR. 4. NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR. 5. Test opener monthly. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board laid flat) at the center of the doorway on the floor. After adjusting either the force or the limit of travel, retest the door opener. Failure to adjust the opener properly may cause severe injury or death. 6. When possible, use the emergency release only when the door is closed. Use caution when using this release with the door open. Weak or broken springs are capable of increasing the rate of door closure and increasing the risk of severe injury or death. 7. KEEP DOORS PROPERLY BALANCED. See your garage door Owner's Manual. An improperly balanced door increases the risk of severe injury or death. Have a trained door system technician make repairs to cables, spring assemblies, and other hardware. 8. SAVE THESE INSTRUCTIONS. If you have any questions, please do not hesitate to contact Genie® customer service at: 1.800.354.3643 10 MAINTENANCE WARNING • Garage door hardware (springs, cables, brackets, pulleys, etc.) are under extreme pressure and tension. • DO NOT attempt to repair or adjust door springs or any hardware, and DO NOT OPERATE garage door automatically or manually if door is improperly balanced or springs are broken. - CONTACT A TRAINED DOOR SYSTEM TECHNICIAN. ROUTINE MONTHLY MAINTENANCE 2. Contact reverse. • Place a 2" x 4" board laid flat on floor. - In center of garage door opening. • Close door by using wall control or remote control. - Door fails to reverse on contact with board (See section 6 "CONTACT REVERSE.") - Opener still fails CONTACT THE GENIE COMPANY OR AN AUTHORIZED GENIE® DEALER. 3. Safe-T-Beam® System. • Red LED blinks. - check alignment (See section 5 ). 1. Door balance. • With the door closed, pull emergency release knob (Carriage Lock) towards the opener to release door from carriage assembly. • Raise door manually approximately 3'- 4' and release. - Door should remain stationary or move very slightly. - If door moves quickly, CONTACT A TRAINED DOOR SYSTEM TECHNICIAN. • Close the door. • Pull emergency release knob towards door to engage carriage. - Operate door using remote. - Door will re-attach itself to carriage assembly. WARNING Use Wall Control supplied with opener. Any other Wall Control can cause the opener to operate unexpectedly. PN# 37026500123 05/15/2009 25