Genie SilentMax 1000 Owner's Manual - Page 11

the same button - learn button

Get Genie SilentMax 1000 PDF manuals and user guides View all Genie SilentMax 1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

3 Required Programming 18 Press and release the same button on the remote (both LED's flash blue and then turn off). The Remote button is now programmed. Repeat as necessary for additional Remotes. To program the same Remote for other garage door openers, repeat the steps above using one of the other two Remote buttons. Each Remote can be programmed for three door openers. BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR IS READY TO USE! PROGRAM SET - NOTE: For Car2U and HomeLink, park the car outside the garage with the ignition key in the "Accessory" position. Follow the Car2U or HomeLink instruction to set the button in the car to Genie mode. PROGRAM IMPORTANT: Your HomeLink® device will ONLY respond to pressing THIS button on your Intellicode remote when it's searching SET - to connect to your remote in "Learn Mode" as described in the HomeLink® instruction manual. 19 Press and release the same button on the remote (the door should open or close). G999-393 Manual-ScrewBeltChain-EN indd 11 11 7/13/12 10 17 AM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
The Remote button is now programmed.
Repeat as necessary for additional Remotes.
To program the same Remote for other garage door openers, repeat
the steps above using one of the other two Remote buttons.
Each Remote can be programmed for three door openers.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR IS
READY TO USE!
NOTE:
For Car2U and HomeLink, park the car outside the garage
with the ignition key in the “Accessory” position.
Follow the Car2U or
HomeLink instruction to set the button in the car to Genie mode.
IMPORTANT:
Your HomeLink® device
will ONLY respond to pressing THIS button
on your Intellicode remote when it's searching
to connect to your remote in "Learn Mode" as
described in the HomeLink® instruction manual.
Required Programming
3
PROGRAM
SET
–
PROGRAM
SET
–
18
Press and release the same button on the remote
(both LED’s flash blue and then turn off).
19
Press and release
the same button
on the remote
(the door should open or close).
11
G999-393 Manual-ScrewBeltChain-EN indd
11
7/13/12
10 17 AM