Genie SilentMax 1000 Owner's Manual - Page 13

4 Optional Programming Clearing Memory FOR Remotes 1 Press the Program Set button on the Powerhead and hold 2 seconds, round LED comes ON. PROGRAM PROGRAM 4 To verify that the memory is cleared, press a remote button that was previously programmed to the Powerhead. T - + SET HOLD 2 seconds 2 Release the Program Set button, round LED goes off and the long LED flashes purple. PROGRAM - + 3 Press up arrow button (+) and down arrow button (-) simultaneously on the Powerhead and hold until both LEDs flash blue and then go OFF. PROGRAM PROGRAM SET SET HOLD HOLD If the memory has been cleared, the Remote will not activate the door opener. NOTE: The garage door opener will operate normally using the Wall Console. NOTE: When the remote is pressed the round LED will flash blue but will not activate the door opener. NOTE: Clearing Remotes from the Powerhead memory will clear ALL programmed Remotes and wireless Keypads. Your opener will no longer recognize any signal received from a missing Remote. All remaining (or recovered) Remotes and wireless Keypads MUST BE reprogrammed as shown on pages 9 and 12. G999-393 Manual-ScrewBeltChain-EN indd 13 (continued next page) 13 7/13/12 10 17 AM