Genie SilentMax 1000 Owner's Manual - Page 7

Program Set button - opener

Get Genie SilentMax 1000 PDF manuals and user guides View all Genie SilentMax 1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

3 Required Programming 5 Press and release the Program Set button (both LEDs flash blue and go off). PROGRAM PROGRAM - + SET The DOWN (closed) limit is programmed. 8 Press and hold the up arrow button (+) until door is fully open, then release. Watch carriage as it approaches the power head to avoid contact with powerhead. PROGRAM SET - HOLD Opening Garage Door (Up Limits) NOTE: Beginning with garage door closed is recommended but not necessary. 6 Press and hold the up arrow button (+) for 2 seconds until the long LED light comes on blue (round LED remains off). PROGRAM PROGRAM SET - SET HOLD 2 seconds 7 Release up arrow button (+) and the round LED will begin flashing. PROGRAM SET - PROGRAM SET - 9 Press and release the Program Set button (both LEDs flash blue and go off). PROGRAM PROGRAM - + ET G999-393 Manual-ScrewBeltChain-EN indd 7 The UP (open) limit is programmed. BOTH DOOR LIMITS ARE NOW PROGRAMMED. 7 7/13/12 10 17 AM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
Required Programming
3
The DOWN (closed) limit is programmed.
Opening Garage Door (Up Limits)
NOTE:
Beginning with garage door closed is recommended but not
necessary.
The UP (open) limit is programmed.
BOTH DOOR LIMITS ARE NOW PROGRAMMED.
PROGRAM
SET
PROGRAM
–
+
5
Press and release the
Program Set button
(both
LEDs flash blue and go off).
PROGRAM
SET
–
PROGRAM
SET
–
HOLD
8
Press and hold the
up arrow button (+)
until door
is fully open, then release. Watch carriage as
it approaches the power head to avoid contact
with powerhead.
PROGRAM
SET
PROGRAM
SET
–
HOLD
2 seconds
HOLD
2 seconds
6
Press and hold the
up arrow button (+)
for
2 seconds until the long LED light comes on blue
(round LED remains off).
PROGRAM
SET
–
7
Release
up arrow button (+)
and the round LED
will begin flashing.
PROGRAM
ET
PROGRAM
–
+
9
Press and release the
Program Set button
(both
LEDs flash blue and go off).
7
G999-393 Manual-ScrewBeltChain-EN indd
7
7/13/12
10 17 AM