Gigabyte H610M K User Manual
Gigabyte H610M K Manual
 |
View all Gigabyte H610M K manuals
Add to My Manuals
Save this manual to your list of manuals |
Gigabyte H610M K manual content summary:
- Gigabyte H610M K | User Manual - Page 1
H610M K User's Manual Rev. 1001 For more product details, please visit GIGABYTE's website. https://www.gigabyte.com/Motherboard/H610M-K-rev-10?m=ma#kf GIGABYTE will reduce paper use in order to fulfill the responsibilities of a global citizen. Also, to reduce the impacts on global warming, the - Gigabyte H610M K | User Manual - Page 2
permission. „„ For detailed product information, carefully read the User's Manual. „„ For quick set-up of the product, refer to the Quick Installation Guide on GIGABYTE's website. https://download.gigabyte.com/FileList/Manual/mb_manual_quick-guide_am5.pdf?m=sw For product-related information, check - Gigabyte H610M K | User Manual - Page 3
Chapter 1 Product Introduction 4 1-1 Motherboard Layout 4 Chapter 2 Hardware Installation 5 2-1 Installation Precautions 5 2-2 Product Specifications 6 2-3 Installing the CPU and CPU Cooler 9 2-4 Installing the Memory 12 2-5 Installing an Expansion Card 13 2-6 Back Panel Connectors 14 - Gigabyte H610M K | User Manual - Page 4
Chapter 1 Product Introduction 1-1 Motherboard Layout R_USB20 SYS_FAN1 ATX_12V_2X4 CPU_FAN DP_HDMI ATX LGA1700 H610M K R_U32 USB_LAN 80 AUDIO PCIEX16 Realtek® GbE LAN Chip iTE® Super I/O CODEC PCIEX1 F_AUDIO BAT M_BIOS SPI_TPM F_USB1 Temperature sensor M2P_SB DDR5_A1 DDR5_B1 5 4 - Gigabyte H610M K | User Manual - Page 5
installation, carefully read the user's manual and follow these procedures: •• Prior when handling electronic components such as a motherboard, CPU or memory. If you do not have an you are uncertain about any installation steps or have a problem related to the use of the product, please consult - Gigabyte H610M K | User Manual - Page 6
® Processors (Go to GIGABYTE's website for the latest CPU support list.) ŠŠ L3 cache varies with CPU Chipset ŠŠ Intel® H610 1 x PCI Express x1 slot, supporting PCIe 3.0 and running at x1 Chipset: - 1 x M.2 connector (Socket 3, M key, type 2280 PCIe 3.0 x4/x2 SSD support) - 2 x SATA 6Gb/s - Gigabyte H610M K | User Manual - Page 7
Panel Connectors I/O Controller Hardware Monitor BIOS ŠŠ 1 x 24-pin ATX main power connector ŠŠ 1 x 8-pin ATX 12V power connector ŠŠ 1 x CPU fan header ŠŠ 1 x system Fan speed control * Whether the fan speed control function is supported will depend on the cooler you install. ŠŠ 1 x 128 Mbit - Gigabyte H610M K | User Manual - Page 8
without prior notice. && Please visit GIGABYTE's website for support lists of CPU, memory modules, SSDs, and M.2 devices. https://www.gigabyte.com/Motherboard/H610M-K-rev-10?m=dl#support-dl && Please visit the SERVICE/SUPPORT\Utility page on GIGABYTE's website to download the latest version - Gigabyte H610M K | User Manual - Page 9
before you begin to install the CPU: •• Make sure that the motherboard supports the CPU. (Go to GIGABYTE's website for the latest CPU support list.) •• Always turn off the computer and unplug the power cord from the power outlet before installing the CPU to prevent hardware damage. •• Locate the - Gigabyte H610M K | User Manual - Page 10
pin one marking (triangle) with the pin one corner of the CPU socket (or you may align the CPU notches with the socket alignment keys) and gently insert the CPU into position. Pin One w j Make sure the CPU is properly installed and then close the load plate. The plastic protec- tive cover will - Gigabyte H610M K | User Manual - Page 11
Be sure to install the CPU cooler after installing the CPU. (Actual installation process may differ depending the CPU cooler to be used. Refer to the user's manual for your CPU cooler.) u Apply an even and thin layer of thermal grease on the surface of the installed CPU. v Place the cooler atop the - Gigabyte H610M K | User Manual - Page 12
and chips be used. (Go to GIGABYTE's website for the latest supported memory speeds and memory modules.) •• supports Dual Channel Technology. After the memory is installed, the BIOS Channel A: DDR5_A1 Channel B: DDR5_B1 Due to CPU limitations, read the following guidelines before installing the - Gigabyte H610M K | User Manual - Page 13
an expansion card: •• Make sure the motherboard supports the expansion card. Carefully read the manual that came with your expansion card. •• Always 6. Turn on your computer. If necessary, go to BIOS Setup to make any required BIOS changes for your expansion card(s). 7. Install the driver provided - Gigabyte H610M K | User Manual - Page 14
sound playback device to DisplayPort/HDMI. (The item name may differ depending on your operating system.) USB 3.2 Gen 1 Port The USB 3.2 Gen 1 port supports the USB 3.2 Gen 1 specification and is compatible to the USB 2.0 specification. Use this port for USB devices. RJ-45 LAN Port The Gigabit - Gigabyte H610M K | User Manual - Page 15
can change the functionality of an audio jack using the audio software. To configure 7.1-channel audio, access the audio software for audio settings. && Please visit GIGABYTE's website for details on configuring the audio software. https://www - Gigabyte H610M K | User Manual - Page 16
2-7 Internal Connectors 41 3 6 13 8 11 10 2 9 5 12 7 1) ATX_12V_2X4 2) ATX 3) CPU_FAN 4) SYS_FAN1 5) SATA3 4/5 6) M2P_SB 7) F_PANEL 8) F_AUDIO 9) F_U32 10) F_USB1 11) SPI_TPM 12) CLR_CMOS 13) BAT Read the following guidelines before connecting external devices: •• First make sure your - Gigabyte H610M K | User Manual - Page 17
design. Connect the power supply cable to the power connector in the correct orientation. The 12V power connector mainly supplies power to the CPU. If the 12V power connector is not connected, the computer will not start. To meet expansion requirements, it is recommended that a power supply - Gigabyte H610M K | User Manual - Page 18
CPU and system from overheating. Overheating may result in damage to the CPU supports a single SATA device. SATA3 5 7 47 G.QBOFPMin No. Definition 1 GND 2 TXP 1 3 TXN 1 4 GND 5 RXN 6 RXP 7 GND To enable hot-plugging for the SATA ports, please navigate to the "BIOS Setup" page of GIGABYTE - Gigabyte H610M K | User Manual - Page 19
6) M2P_SB (M.2 Socket 3 Connector) The M.2 connector on the motherboard supports only M.2 PCIe SSDs. 110 80 60 42 Follow the steps below 's tab into the mounting hole. * Types of M.2 SSDs supported by the M.2 connector: M.2 PCIe x4 SSD M.2 PCIe x2 SSD M.2 SATA SSD M2P_SB a a r - 19 - - Gigabyte H610M K | User Manual - Page 20
"BIOS Setup" page of GIGABYTE's website and search for "Soft-Off by PWR-BTTN" for more information). •• SPEAK (Speaker): Connects to the speaker on the chassis front panel. The system reports system startup status by issuing a beep code. One single short beep will be heard if no problem - Gigabyte H610M K | User Manual - Page 21
8) F_AUDIO (Front Panel Audio Header) The front panel audio header supports High Definition audio (HD). You may connect your chassis front panel audio module to this header. Make sure the wire assignments of the module connector - Gigabyte H610M K | User Manual - Page 22
10) F_USB1 (USB 2.0/1.1 Header) _S The header conforms to USB 2.0/1.1 specification. Each USB header can provide two USB ports via an optional USB bracket. For purchasing the optional USB bracket, please contact the local dealer. _ B S_ B Pin No. DefiBnition 1 Power (5V) 2 Power (5V) 9 1 - Gigabyte H610M K | User Manual - Page 23
before clearing the CMOS values. •• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or manually configure the BIOS settings (please navigate to the "BIOS Setup" page of GIGABYTE's website for more information). 13) BAT (Battery) The battery provides - Gigabyte H610M K | User Manual - Page 24
and updates the BIOS. For instructions on using the Q-Flash and @BIOS utilities, please navigate to the "Unique Features" page of GIGABYTE's website and search for "BIOS Update Utilities." •• Because BIOS flashing is potentially risky, if you do not encounter problems using the current version - Gigabyte H610M K | User Manual - Page 25
Startup Screen: The following startup Logo screen will appear when the computer boots. Function Keys Function Keys: : BIOS SETUP\Q-FLASH Press the key to enter BIOS Setup or to access the Q-Flash utility in BIOS Setup. : BOOT MENU Boot Menu allows you to set the first boot device - Gigabyte H610M K | User Manual - Page 26
and GIGABYTE applications via APP Center. Click Install to proceed with the installation. (In BIOS Setup, GIGABYTE's website for more software information. https://www.gigabyte.com/WebPage/879/h610-app.html && Please visit GIGABYTE's website for more troubleshooting information. https://www.gigabyte - Gigabyte H610M K | User Manual - Page 27
Product Name: Motherboard Trade Name: GIGABYTE Model Number: H610M K Responsible Party - U.S. Contact and used in accordance with manufacturer's instructions, may cause harmful interference to radio communications office, your household waste disposal service or where you purchased the product - Gigabyte H610M K | User Manual - Page 28
-2-8912-4000, FAX: +886-2-8912-4005 Tech. and Non-Tech. Support (Sales/Marketing) : https://esupport.gigabyte.com WEB address (English): https://www.gigabyte.com WEB address (Chinese): https://www.gigabyte.com/tw •• GIGABYTE eSupport To submit a technical or non-technical (Sales/Marketing) question
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
 |
 |
For more product details, please visit GIGABYTE's website.
GIGABYTE will reduce paper use in order to fulfill the responsibilities of a global citizen.
Also, to reduce the impacts on global warming, the packaging materials of this product
are recyclable and reusable. GIGABYTE works with you to protect the environment.
H610M K
User's Manual
Rev. 1001