Haier DW9-TFE3ME User Manual - Page 17

en End of programme Six beeps will indicate that the wash cycle has finished and the state indicators "A" light. Switching the dishwasher OFF Several minutes after the programme has ended: Set On-Off button to Off Open the door . Turn the water tap off. Remove dishes, etc. when they have cooled down. Notice: When the appliance is already underway press the button "B" for 3 seconds, all of the settings will be cancelled. Interrupping the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion. Delayed start programming You can delay the start of a programme in increments of 1 hour up to 24 hours. Close the door after loading the appliance. Switch dishwasher ON. Immediately press the Delayed Start button " F ", the delayed start indicator " E " blinks, the remaining time indicator " G " changes to " ". Press the Delayed Start button for 2 seconds until the numerical display show the required delay. To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator " E" goes out. Rotate programme knob " J " to select the desired programme. A CE H B DF G I J 16