Haier DW9-TFE3ME User Manual - Page 18

en After 3 seconds the delayed start indicator " E " blinks, the time-remaining indicator " G " will blink and decrease , the programme will start until the delayed start indicator " G " goes out . Cancelling or modifying a cycle A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, " Loading the detergent "). To modify a cycle that is already underway, follow the instructions contained in the paragraph entitled "Reset drain function", and select the programme you wish (see the paragraph entitled, "Switching the dishwasher ON"). A CE H 3in1 function B DF G I When using "3 in 1"combination products, the rinse-aid and salt lights are no longer useful. It may be helpful to select the lowest possible setting for water hardness. If you decide to switch to the use of a standard detergent system we advise that you: 1: Refill both the salt and rinse aid compartments. 2: Switch the water hardness setting to the highest possible position and run for three normal cycles without a load. 3: Readjust the water hardness setting again according to the conditions for your region (For more information please refer to your instruction manual). Warning Do not place the tablets in the tub or the cutlery basket as this will result in poorer wash results. The tablets should be placed in the detergent doser. Notice: The usage of 3 in 1 or similar tablets is forbidden when Heat Wash, Rapid Wash and Soak programmes are selected. Reset drain function You can use Reset drain function to stop the washing cycle under running by Rotating the knob to "Reset ", and the appliance will stop after a few minutes drain phase. 17