Haier HA500TX User Manual

Haier HA500TX Manual

Get Haier HA500TX PDF manuals and user guides View all Haier HA500TX manuals
Add to My Manuals
Save this manual to your list of manuals

Haier HA500TX manual content summary:

  • Haier HA500TX | User Manual - Page 1
    Wiring Circuit 15
  • Haier HA500TX | User Manual - Page 2
    Technical Specification Item Power supply Model Maximum working current (A) Water pressure Washing power Spinning power (MPa) (W) (W) Washing program Washing capacity Heating power Size (HXDXW) Weight (kg) (W) (mm) (kg) HA600TX 220V~/50Hz 10 0.05 P 1 330 650 16 6 1950 850x550x595 72 14
  • Haier HA500TX | User Manual - Page 3
    Trouble shooting The following circumstances do not constitute problems. Do not contact the maintenance service until the problem has been confirmed. Problem The washing machine fails to operate Possible Cause Poor connection to power supply Power failure Door is not properly closed Machine has
  • Haier HA500TX | User Manual - Page 4
    Maintenance 1. Turn of the water and electricity supply after every wash. Open the door to prevent the formation of moisture and odors. If the washing machine is left idle for a long period, drain any remaining water in the machine and replace the drainage hose. 2. Unplug the machine during
  • Haier HA500TX | User Manual - Page 5
    Washing Methods 4. Washing temperature Setting Set the washing temperature as required, otherwise, set at position * when heating is not needed. 5. Selecting the function button Select function buttons as required (refer to the directions printed on the operation panel) ,otherwise keep all the
  • Haier HA500TX | User Manual - Page 6
    Washing Methods 1. Laundry loading Evenly load the laundry in the washing machine and then tightly close the door of the washing machine Note: 1) When first using the washing machine, let it run unloaded for one program to prevent the laundry from being tainted by oil or dirty water from the
  • Haier HA500TX | User Manual - Page 7
    Preparation 1. Power supply Plug in the power supply 220V~/50Hz. 2. Water supply Turn on the tap ensure that the water is clear. Caution: Before staring the washing machine turn on the water faucrt to ensure that the water faucet and the water inlet hose are connected correctly and do not leak.
  • Haier HA500TX | User Manual - Page 8
    Program Selection Intense Delicate 8 9 Delicate 10 11 12 13 14 15 16 Note: "O" means softener liquid detergent can be added when necessary. " " means detergent can be added when neccessary. "X" means no detergent can be added. 8
  • Haier HA500TX | User Manual - Page 9
    machine will stop. G Power light The light will illuminates when the power supply is connected. ON OFF H Door Lock Light Remember that only when the washer doesn't work, we can open the door. After the washing program finish,after 3 minutes, when the self-lock meter turn off, we can open the
  • Haier HA500TX | User Manual - Page 10
    is se-  lected when the knob is set at *. C Detergent Dispenser. The detergent dispenser is divided into 4 compartments marked 1,2,A,C 1 Pre-wash detergent 2 Wash detergent A Softeners, conditioners, perfumes C Bleach 6
  • Haier HA500TX | User Manual - Page 11
    water drainage support supplied as an accessory for proper installation of the water drainage hose .fix the water drainage hose support with waterproof are compatible ,Refer to a washing machine technician or a Haier designated service point for power cable replacement.The washing machine should be
  • Haier HA500TX | User Manual - Page 12
    the foam base). = Remove the packing screws as shown in figure 2. The packing bolts protect the appliance from shock during transportation The steps below should be followed before using the appliance, 1. Remove the rear panel of the washing machine; 2. remove the three packing bolts from the rear
  • Haier HA500TX | User Manual - Page 13
    Matters Needing Attention 3. Never place heavy objects ,a heating applianceor a water container on the top panel of the washing machine. 4. Do not wash foam rubber or similar sponge materials. 5. Before washing, do up zippers, buttons ,laces and repair damaged areas,underwear or small articals
  • Haier HA500TX | User Manual - Page 14
    of high moisture as water droplets may form on electrical components, Air dry the appliance if the washing machine components become wet. 9. The washing to the water supply,take the necessory precautions or con-tact the local service center if the con-nection is poor or there is a water leakage
  • Haier HA500TX | User Manual - Page 15
    unplugging the washing machine. 3. Fuses in the power circuit should be rated for 15A. Refer to a washing machine technician or a Haier designated service point for power cable replacement. 4. For your safety, dry hands before touching the washing machine and wear appropriate footwear . 5. Do
  • Haier HA500TX | User Manual - Page 16
    Earth terminal Back plate screw (3) Drainage hose Drainage hose clip Packing bolt (3) Back plate Caution and Warning symbols For your safety, any instructions in this manual with this "Warning" sign shall be strictly followed. For your safety and to prevent damages to the washing machine, any
  • Haier HA500TX | User Manual - Page 17
    Operation Manual HA600TX Automatic Drum Washing Machine Table of Contents Before using Names of Parts inside Functions 6-7 During using Program Selection 8 Preparation 9 Washing Methods 10-11 Maintenance Maintenance 12 Trouble Shooting 13 Technical Specification 14 Wiring Circuit 15
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
Wiring Circuit
15