Haier HDT18PA User Manual - Page 23
Installing Your Dishwasher - countertop dishwasher
UPC - 688057190419
View all Haier HDT18PA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
GB Installing Your Dishwasher: Read install instructions carefully before installation. Caution: If, after completing these steps, you are unsure that unit is properly installed, contact a qualified installer. To ensure that your appliance is properly in stalled it is recommended that it be installed by a certified installer. In order for this dishwasher to work, the following are required: COLD WATER SUPPLY DRAINAGE FOR USED WATER ELECTRICITY: 115 VOLT, 60Hz Outlet GROUNDING HORIZONTAL FLAT SURFACE Note: For your convenience, the water inlet hose and drain hose are preinstalled to the dishwasher from the factory. Both hoses are located behind the dish washer at the left bottom of the dishwasher. 1. You dishwasher must be placed on horizontal flat surface near by the sink on the kitchen bench (countertop). Placing the dishwasher as near to a sink as possible to allow for proper installation of the water inlet and drainage hoses. 2. Connect the other end of water inlet hose to the cold water faucet. (Quick Connect Sink Adapter is supplied) 3. The other end of the drain hose must be placed properly in the sink or at your drain outlet in order to let used water drained out from the dishwasher. 4. Plug in the dishwasher to a regular 115 Volt / 60 Hz, 15 Amp. Outlet. Dishwasher Water Inlet Hose Faucet Kitchen Counter Top Drain Hose Note: Note: This figure is for illustration purpose only. Inspect carefully for any water leak around and back of the machine. If any leak occurs, double check to see if any connections are loose. You may need to tighten any loose connections. 22