Haier HM500T User Manual

Haier HM500T Manual

Haier HM500T manual content summary:

  • Haier HM500T | User Manual - Page 1
    AUTOMATIC DRUM WASHING MACHINE HM500X HM500TX HM600X HM600TX INSTRUCTIONS FOR INSTALLATION AND OPERATION 0020504797
  • Haier HM500T | User Manual - Page 2
    are at your disposal to help you resolve your daily household problems. Your machine is easy to use. Read this owner's manual carefully since contains all the instructions for safe installation, use and maintenance. Remember to keep your owner's manual in a safe place so that you can refer to it
  • Haier HM500T | User Manual - Page 3
    FUNCTION INTRODUCTION 3-5 INSTALLATION 6-8 CLOSE UP 9-11 USING INSTRUCTIONS 12-16 MAINTENANCE 17 SOLUTION TO PROBLEMS 18-19 ATTACHED CHART: GUIDE FOR SELECTING PROGRAMME 20-21 WARNING 22 2
  • Haier HM500T | User Manual - Page 4
    FUNCTION INTRODUCTION FUNCTION COMPARING TABLE FUNCTION MODE Washing capacity Programmes HM600TX HM500TX HM600X HM500X 6kg 6kg 6kg 6kg 16 16 16 16 Cotton Synthetic Wool Thermostat ajustable(0-90 C) Cold wash button Economic wash button No soak Spin
  • Haier HM500T | User Manual - Page 5
    FUNCTION INTRODUCTION Characteristics of HM600X HM500X European and AsiaAesthetic design, elegant and beautiful. Three types of wash: rinse, beat and rain effect. Changeable washing function: cold wash and hot wash,No soak Three types of laundry: cotton, synthetic and wool, with 16 cycles. A large
  • Haier HM500T | User Manual - Page 6
    FUNCTION INTRODUCTION Characteristics of HM600TX HM500TX European and AsiaAesthetic design, elegant and beautiful. Three types of wash: rinse, beat and rain effect. Changeable washing function: cold wash and hot wash,No
  • Haier HM500T | User Manual - Page 7
    holes left open by the screws with the plastic caps provided in the packet containing the owner's manual. And rescrew the holes where the iron piece is taken down with the former two screws.Attention carpeting, remember to check that the ventilation in the support area is not plugged. Fig.1 Fig.2 6
  • Haier HM500T | User Manual - Page 8
    wire supplied together with the machine and the earthing terminal located on the left-upper corner of the back of your machine (Warning: this appliance must be earthed as a safety measure according to the law). Make sure that the voltage and frequency available correspond with the values stated on
  • Haier HM500T | User Manual - Page 9
    fixed in the appropriate hook on the upper part of the back panel (Fig.4) or use the supplied support to fix the drain hose.(Fig.5) Fig.4 Connecting WaterSupply Fig.5 Insert stainless steel screen washers into end of each supply hose and attach that end of supply hose to your 3/4" water tap spigot
  • Haier HM500T | User Manual - Page 10
    Close up G DC F IH A G DC F IH 15 16 1 2 14 3 13 4 12 11 5 10 9 8 76 A 15 16 1 2 14 3 13 4 12 11 5 10 9 8 76 G DC E IH B A MAX 80 70 30 40 50 60 15 16 1 2 14 3 13 4 12 11 5 10 9 8 76 G DC E IH B A 9 MAX 30 80 70 40 50 60 15 16 1 2 14 3 13
  • Haier HM500T | User Manual - Page 11
    Close up 15 16 1 2 14 3 13 4 12 11 5 10 9 8 76 MAX 30 80 70 40 50 60 A Programme selector Knob. By turning this dial (clockwise only) you can select from sixteen wash programmes the one most suited for your washing. 1~7 cotton cycle 8~12 synthetic cycle 13~16 wool cycle B Programme
  • Haier HM500T | User Manual - Page 12
    dispenser is divided into 4 compartments marked 1,2,A,C:(See Fig.8) 1 Pre-wash detergent 2 Wash detergent A Softeners, conditioners, perfumes C Bleach Fig.8 H Door Lock Light Remember that only when the washer doesn't work,we can open the door. After the washing program finish,after 3 minutes, when
  • Haier HM500T | User Manual - Page 13
    Using instructions:Your machine offers the best results when... The weight is right In order to get the excellent results that you would expect from your washing machine, it is important to load the washer correctly. You should therefore choose the quantity of each type of fabric that you want to
  • Haier HM500T | User Manual - Page 14
    Using instructions:Your machine offers the best results when... The correct programme to select the best programme. Hints on choosing the programme are shown in the table on pages of this manual. Once you have selected a programme, just turn dial A clockwise until the chosen programme lines up with
  • Haier HM500T | User Manual - Page 15
    Using instructions:Your machine offers the best results when... The detergent has been put in properly The 4 compartments marked 1, 2, A and C (Fig.9) should be used as follows: 1 Pre-wash detergent 2 Wash detergent A Conditioner, starch, scents C Bleach Fig.9 Remember that it is important to use
  • Haier HM500T | User Manual - Page 16
    table will guide you: Laundry Compart.1 prewash Compart.2 wash Compart.A Compart.C Normally 1/2 measuring 1 and 1/2 Softeners Bleach soiled cup measuring (see note 'A') (see note 'C') cups When using concentrated detergents, remember to keep to the manufacturer's instructions using only
  • Haier HM500T | User Manual - Page 17
    Using instructions:Your machine offers the best results when... The cycle is started You can now start washing. We would advise you, especially the first few times,
  • Haier HM500T | User Manual - Page 18
    Fig.8 1. Ensure that your machine was installed according to the installation manual that comes with this booklet. 2. Avoid at all costs using solvents off the tap, and open the door to avoid unpleasant smell. 5. Your washer is equipped with a self-cleaning pump. It is therefore not necessary to
  • Haier HM500T | User Manual - Page 19
    Solution to Problems Even though your washing machine has been carefully designed and constructed, something could still go a miss with your machine. Before rushing to phone one of our service centres, however, please by hand; that the amount used is that shown in this manual and not more. 18
  • Haier HM500T | User Manual - Page 20
    Solution to Problems The machine vibrates too much when spinning Check that: the transit bolts have been removed (see installation manual); the machine is level; the washing load is according to the instructions given in this booklet. The machine Check that: stops operating there is a sudden
  • Haier HM500T | User Manual - Page 21
    Guide for selecting programme 20 Type of fabric & degree of dirtiness Position Program crease soak Rinses with automatic introduction of softener-anti-crease soak Push down the no soak button or manually turn timer knob to the symbol" ", the machine will continue to work Draining-spin Wash cycle
  • Haier HM500T | User Manual - Page 22
    be replaced by a special card or assembly available from the manufacturer or it is service agent. 2. It a stationray appliance is provided with a supply card and a plug, the instructions shall state that the appliance must be positioned so that the plug is accessible. Note: this requirement dose not
  • Haier HM500T | User Manual - Page 23
    WIRING CIRCUIT (HM600TX HM500TX) TH40 I1=ON/OFF I2=ECONOMIC WASH I3=NO SOAK L Line P2 2- level pressure switch N Neutrol SL Line LED SO Door lock MR Thermol lock MT Timer motor RR Heating element PS Drain pump EVF Cold water electrovolve P1 1- level pressure switch TH40 40 C thermostat 22
  • Haier HM500T | User Manual - Page 24
    WIRING CIRCUIT (HM600X HM500X) I1=ON/OFF I2=COLD WASH I3=NO SOAK L Line P2 2-level pressure switch N Neutrol SL Line LED SO Door lock LED MR Thermol lock EVF Cold water electrovolve MT Timer motor RR Heating element PS Drain pump TH40 40 C thermostat P1 1-level pressure switch TH80 80 C
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

AUTOMATIC DRUM
WASHING MACHINE
INSTRUCTIONS FOR
INSTALLATION AND
OPERATION
HM500X HM500TX
HM600X HM600TX
0020504797