Haier HSU-09HEA103 User Manual
Haier HSU-09HEA103 Manual
 |
View all Haier HSU-09HEA103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier HSU-09HEA103 manual content summary:
- Haier HSU-09HEA103 | User Manual - Page 1
it. Indoor Unit ƽ Place, robust not causing vibration, where the body can be supported sufficiently. ƽ Place, not affected by heat or steam generated in the vicinity, where your reference. Read this manual before installation Explain sufficiently the operating means to the user according to - Haier HSU-09HEA103 | User Manual - Page 2
/outdoor electric cable Lid for right piping Lid for under piping pipe Heat insulation material Lid for left piping Drain hose Piping Pipe supporting plate Fix with adhesive tape ƽ Indoor/outdoor electric cable and drain hose must be bound with refrigerant piping by protecting tape. [ Other - Haier HSU-09HEA103 | User Manual - Page 3
R2 HSU-09HRA03/R2 HSU-12H EK03/R2 HSU-12HRA03/R2 HSU-0 7HEA03 /R2 HSU-12HVA03/R2 HSU-09HEA03/R2 HSU-09HEA03 /R2-I HSU-12HEA03 /R2 HSU-12HEA03 /R2-I HSU-09HEA103/R2 HSU-09RH03/R2 HSU-12HEA103/R2 HSU-12RH03/R2 1. If the supply cord is damaged, it must be replaced by the manufacturer or its service 12 - Haier HSU-09HEA103 | User Manual - Page 4
valve 3-way valve 2-way valve 3-way valve Step 7. 2-way valve 3-way valve Service port cap Valve rod cap Valve rod cap CAUTION ƽ If the refrigerant of the Please kindly explain to our customers how to operate through the instruction manual. Check Items for Test Run Put check mark in boxes Gas - Haier HSU-09HEA103 | User Manual - Page 5
Manual de instalación de aparato de aire acondicionado Preparación Herramientas necesarias para flejar fielmente el producto adquirido y debe utilizarse únicamente como referencia. Lea este manual antes de la instalación Explique el uso del aparato al usuario siguiendo las instrucciones de este - Haier HSU-09HEA103 | User Manual - Page 6
Control remoto (1) Batería seca R-03 (2) Placa de montaje (1) Tapón de plástico (4) Tornillo ø4X25 (4) Accesorios Manguera de drenaje (1) Acolchado (4) Codo de drenaje (1) Placa de soporte del tubo (1) [Izquierda • Entubación trasera izquierda] En caso de realizar la entubación por el lado - Haier HSU-09HEA103 | User Manual - Page 7
HSU-09H EK03/R2 HSU-09HRA03/R2 HSU-12H EK03/R2 HSU-12HRA03/R2 HSU-0 7HEA03 /R2 HSU-12HVA03/R2 HSU-09HEA03/R2 HSU-09HEA03 /R2-I HSU-12HEA03 /R2 HSU-12HEA03 /R2-I HSU-09HEA103/R2 HSU-09RH03/R2 HSU-12HEA103/R2 HSU-12RH03/R2 líquido/gas 9,52mm (3/8") Lado de gas 12,7mm (1/2") Lado de gas 15,88mm (5/8") - Haier HSU-09HEA103 | User Manual - Page 8
Botella de refrigerante y colector de carga. Prueba de instalación y ejecución de la prueba Explique al cliente cómo utilizar el aparato utilizando el manual de instrucciones. Compruebe los siguientes puntos de prueba Escriba una marca en los cuadros ¿Existe una fuga de gas en la conexión del - Haier HSU-09HEA103 | User Manual - Page 9
fissare l'unità usando un pannello antivibrazione. Più di 15cm Attenersi al prodotto acquistato: le immagini sono solo per riferimento. Leggere questo manuale prima dell'installazione Spiegare all'utente in modo esauriente il funzionamento e l'uso del condizionatore in base alle istruzioni di questo - Haier HSU-09HEA103 | User Manual - Page 10
Parti accessorie Telecomando (1) Batteria a secco R-03 (2) Tubo di scarico (1) Cuscino (4) Piastra di montaggio (1) Coperchio di plastica (4) Viti Ø4X25 (4) Giunto a gomito dello scarico (1) Piastra di supporto tubature (1) Selezione dei tubi Tubo per liquidi (Ø) Tubo per gas (Ø) 6,35mm - Haier HSU-09HEA103 | User Manual - Page 11
liquidi/gas 9.52mm (3/8") Lato gas 12,7mm (1/2") Lato gas 15,88mm (5/8") HSU-09H EK03/R2 HSU-12H EK03/R2 HSU-0 7HEA03 /R2 HSU-09HEA03 /R2 HSU-12HEA03 /R2 HSU-09HEA103/R2 HSU-12HEA103/R2 HSU-09HRA03 /R2 HSU-12HRA03 /R2 HSU-12HVA03/R2 HSU-09HEA03 /R2-I HSU-12HEA03 /R2-I HSU-09RH03/R2 HSU-12RH03/R2 - Haier HSU-09HEA103 | User Manual - Page 12
accuratamente al cliente come funziona e come si usa il condizionatore in base alle istruzioni del manuale d'uso. Elenco di controllo per il collaudo Fare un segno di spunta nelle caselle Perdita della temperatura d'ambiente è normale? 3. Inserire il dado svasato 4. Svasare il tubo 12 - Haier HSU-09HEA103 | User Manual - Page 13
jour et qui soit suffisamment ventilé. ● Sélectionnez un emplacement capable de supporter l'unité où les vibrations et le bruit n'augmentent pas. ● Sélectionnez un être installée sur un mur, un toit ou la toiture, fixez un support avec des clous ou des fils en tenant compte des séismes et vents forts - Haier HSU-09HEA103 | User Manual - Page 14
rieures Couvercle pour tuyauterie de droite Couvercle de dessous Matériau d'isolation thermique Tuyau de vidange Couvercle pour tuyauterie de gauche Tuyauterie Plaque de support de tuyau Fixez avec du ruban adhésif ● Le câble des unités intérieures/extérieures et le tuyau de vidange doivent être - Haier HSU-09HEA103 | User Manual - Page 15
N.m Clé Clé dynamo- métrique Gaz 12,7mm (1/2") Gaz 15,88mm (5/8") 55N.m 60 HSU-09H EK03/R2 HSU-09HRA03/R2 HSU-12H EK03/R2 HSU-12HRA03/R2 HSU-0 7HEA03 /R2 HSU-12HVA03/R2 HSU-09HEA03/R2 HSU-09HEA03 /R2-I HSU-12HEA03 /R2 HSU-12HEA03 /R2-I HSU-09HEA103/R2 HSU-09RH03/R2 HSU-12HEA103/R2 HSU-12RH03/R2 - Haier HSU-09HEA103 | User Manual - Page 16
3. Mettez sous vide pendant plus de 15 min. Vérifiez également le manomètre qui doit indiquer -0.1MPa (76 cm Hg) sur le côté basse pression. Après avoir effectué le vide, fermez la poignée Lo dans le collecteur à manomètre et arrêtez l'opération de la pompe à vide. Inspectez l'indicateur et observez
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
F
A
C
E
D
Drawing for the installation of indoor and outdoor units
Optional parts for piping
Non-adhesive tape
Adhesive tape
Saddle (L.S) with screws
Connecting electric cable
for indoor and outdoor
Drain hose
Heating insulating material
Piping hole cover
Floor fixing dimensions of the
outdoor unit (Unit:mm)
Fixing of outdoor unit
Fix the unit to concrete or block
with bolts (10mm) and nuts firmly
and horizontally.
When fitting the unit to wall
surface, roof or rooftop, fix
a supporter surely with nails
or wires in consideration of
earthquake and strong wind.
If vibration may affect the
house, fix the unit by attaching a
vibration-proof mat.
The marks from
to
in the figure are the
parts numbers.
The distance between
the indoor unit and the
floor should be more
than 2m.
The models adopt HFC free refrigerant R410A
more than
10cm
more than 5cm
more than 10cm
more than 10cm
more than
10cm
more than15cm
more than 60cm
A
G
Necessary Tools for Installation
Driver
Torque wrench
(17mm,22mm,26mm)
Nipper
Reamer
Hacksaw
Pipe cutter
Gas leakage detector or
soap-and-water solution
Hole core drill
Flaring tool
Spanner(17,19 and 26mm)
Knife
Measuring tape
Indoor Unit
Place, robust not causing vibration, where the body can be supported sufficiently.
Place, not affected by heat or steam generated in the vicinity, where inlet and outlet of the
unit are not disturbed.
Place, possible to drain easily, where piping can be connected with the outdoor unit.
Place, where cold air can be spread in a room entirely.
Place, nearby a power receptacle, with enough space around. (Refer to drawings).
Place where the distance of more than lm from televisions, radios, wireless apparatuses
and fluorescent lamps can be left.
In the case of fixing the remote controller on a wall, place where the indoor unit can
receive signals when the fluorescent lamps in the room are lightened.
Outdoor Unit
Place, which is less affected by rain or direct sunlight and is sufficiently ventilated.
Place, possible to bear the unit, where vibration and noise are not increased.
Place, where discharged wind and noise do not cause a nuisance to the neighbors.
Place, where a distance marked
±
is available as illustrated in the above figure.
Before inserting power plug into receptacle, check the voltage without fail.
The power source is the same as the corresponding name plate.
Install an exclusive branch circuit of the power.
A receptacle shall be set up in a distance where the power cable can be
reached.Do not extend the cable by cutting it.
Selection of Installation Place
Power
Source
A
F
C
E
D
G
B
Arrangement of piping
directions
Rear left
Left
Rear
right
Right
Below
G
Preparation
Please be subject to the actual product purchased , the above picture is just for your reference.
Attention must be paid to
the rising up of drain hose
Read this manual before installation
Explain sufficiently the operating means to the user according to this manual
NO.00105
31113
Installation Manual of Room Air Conditioner