Haier HWM65-0523S User Manual
Haier HWM65-0523S Manual
 |
View all Haier HWM65-0523S manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier HWM65-0523S manual content summary:
- Haier HWM65-0523S | User Manual - Page 1
Twin-tub Washing Machine with Pump User's manual This manual is for HWM60-0523S Please read this manual carefully before using. Retain it for future reference. - Haier HWM65-0523S | User Manual - Page 2
Contents Names of the parts Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Trouble-Shooting *Answers to question Packing list *Specification - Haier HWM65-0523S | User Manual - Page 3
Names of the parts Wash selector Wash timer Water-filling entrance Control panel Overflow filter Water level adjusting lever Outer cover of the spin tub Inner cover of the spin tub Spin timer Spin tub frame Spin tub Cabinet Lint filter(Installed by user) Power cord Pulsator Wash tub Wash tub - Haier HWM65-0523S | User Manual - Page 4
the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean. Do not put the machine at damp place like the bathroom . Never wash it with water - Haier HWM65-0523S | User Manual - Page 5
Safety precautions Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. Take special care of the children. Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing - Haier HWM65-0523S | User Manual - Page 6
Installation and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain - Haier HWM65-0523S | User Manual - Page 7
How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Soft item Extend the drain hose from the side of spin tub Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the - Haier HWM65-0523S | User Manual - Page 8
Preparation before washing Preparation before washing 1.Connect the water inlet hose. 2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put the drain hose up to suitable - Haier HWM65-0523S | User Manual - Page 9
to lose color. The whitener shall not touch the laundries directly. Refer to the user's manual for the usage and quantity of the whitener. For powder whitener, please dissolve it before using washing powder is different. Please refer to the instruction of the washing powder for the detail dosage. 7 - Haier HWM65-0523S | User Manual - Page 10
, first set to 5 minute then turn it back. it can increase the service life of the timer). Wash selector (standard current, strong current) OFF WATER minute, first set to 2 minute then turn it back. it can increase the service life of the timer). OFF SPIN TIMER Wash 1. Fill the water and add the - Haier HWM65-0523S | User Manual - Page 11
Spinning 1.Put the laundries into the spin tub evenly and smoothly. 2.Spin (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. Push Gland Push Proper The laundries Proper No gland are slanting (2) Close the inner and outer cover of the spin tub. - Haier HWM65-0523S | User Manual - Page 12
Disposal after washing After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Cleaning the lint filter The lint filter must - Haier HWM65-0523S | User Manual - Page 13
Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). Water level adjusting lever Corrugation Pipe 3. Cleaning the overflow filter Clean the lint around the filter and flush with tap - Haier HWM65-0523S | User Manual - Page 14
Trouble-shooting Answers to question If the laundries fall to the outer side of the spin tub If the laundries fall to the outer side of the spin tub, Please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. When the remained - Haier HWM65-0523S | User Manual - Page 15
Trouble-shooting Answers to question (If there's breakdown, please pull off the power to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomena The reason The machine does not - Haier HWM65-0523S | User Manual - Page 16
Packing list Name User's manual Water inlet hose Lint filter Gland Twin-tub washing machine Quantity One piece One piece One piece One piece One set Specification Water level/Water
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
 |
 |
Twin-tub Washing Machine with Pump
User's
manual
This manual is for
HWM60-0523S
Please read this manual
carefully before using.
Retain it for future reference.