Haier QAS740RMSS Installation Instructions
Haier QAS740RMSS Manual
 |
View all Haier QAS740RMSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier QAS740RMSS manual content summary:
- Haier QAS740RMSS | Installation Instructions - Page 1
one at no cost. (In Canada, call 1.800.561.3344.) For installation instructions of the bracket, visit: GEAppliances.com. (In Canada, GEAppliances.ca.) Anti at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting - Haier QAS740RMSS | Installation Instructions - Page 2
1 ELECTRICAL REQUIREMENTS WARNING This appliance must be properly grounded. WARNING All new constructions, mobile homes, recreational vehicles and installations where local codes do not allow grounding through neutral, require a 4-conductor UL-listed range cord. WARNING To prevent fire or shock, do - Haier QAS740RMSS | Installation Instructions - Page 3
. Do not remove the ground strap. Failure follow this instruction may result in potential Neutral terminal shock hazard. WARNING Fire block openings. Be certain the white wire is in the center. On certain models, the wire must be inserted through an opening in the ground strap. Securely tighten - Haier QAS740RMSS | Installation Instructions - Page 4
a properly installed anti tip bracket. Follow instructions supplied with ANTI-TIP bracket. Anti-Tip fuses are replaced. • Be sure power is in service to the building. • Check that all packing materials smoothly. If they do not, see the Owner's Manual for proper replacement. • Check to make sure the - Haier QAS740RMSS | Installation Instructions - Page 5
Instrucciones de instalación Cocinas eléctricas compactas ¿Preguntas? Llame a GE Appliances al 800.GE.CARES (800.432.2737) o visita GEAppliances.com. En Canadá, llame 1.800.561.3344 o visita GEAppliances.ca. ANTES DE COMENZAR Lea estas instrucciones por completo y con detenimiento. • IMPORTANTE - - Haier QAS740RMSS | Installation Instructions - Page 6
1 REQUERIMIENTOS ELÉCTRICOS ADVERTENCIA Esta unidad debe contar con una adecuada conexión a tierra. ADVERTENCIA Todas las construcciones nuevas, casas rodantes, vehículos recreativos e instalaciones donde los códigos locales no permiten una conexión a tierra a través de un neutral requieren un cable - Haier QAS740RMSS | Installation Instructions - Page 7
3 INSTALACIÓN DEL BORDE TRASERO Hay dos opciones para instalar el borde trasero en la parte trasera de la cocina con los 4 tornillos provistos. Nunca deben quitarse los espaciadores provistos. Parte Trasera de la Cocina Borde Trasero Espaciadores Parte Trasera de la Cocina Borde Trasero - Haier QAS740RMSS | Installation Instructions - Page 8
se hayan calentado. • Controle que la puerta y el cajón se encuentren paralelos y que los dos funcionen correctamente. Si no es así, consulte el Manual del propietario para un reemplazo adecuado. • Asegúrese de que el soporte anti volcaduras se encuentre instalado. Verifique que el soporte anti
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
— Save these
instructions for local inspector’s use.
•
IMPORTANT
— Observe all
governing codes and ordinances.
•
Note to Installer
– Be sure to leave these
instructions with consumer.
•
Note to consumer
– Keep these
instructions for future reference.
•
Skill level – Installation of this appliance
requires a qualified installer or electrician.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation is
not covered under warranty.
Installation Instructions
Compact Electric Ranges
MATERIALS YOU MAY NEED
TOOLS YOU WILL NEED
(UL Listed 40 AMP)
4-Wire Cord 4’ long OR
3-Wire Cord 4’ long
Squeeze Connector
(For Conduit
Installations Only)
Drill with 1/8” Bit
Safety Glasses
Adjustable Wrench
Level
Tin Snips
Tape Measure
Pliers
1/4” Nut Driver
Questions? Call GE Appliances at 1.800.GE.CARES (1.800.432.2737) or visit
GEAppliances.com. In Canada, call 1.800.561.3344 or visit GEAppliances.ca.
DIMENSIONS AND
CLEARANCES
Provide adequate clearances between the
range and adjacent combustible surfaces.
These dimensions must be met for safe use of
your range.
Installation of a listed microwave oven or
cooking appliance over the cooktop shall
conform to the installation instructions packed
with that appliance.
NOTE:
Use a 4’ power cord to prevent
interference with the storage drawer. Power cords
4
1
2
’ to 6’ long may have to be dressed to allow for
proper drawer closing.
MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:
A.
Make sure the wall covering, countertop,
flooring and cabinets around the range can
withstand the heat (up to 200°F) generated by
the range.
B.
Allow 30” minimum clearance between surface
units and bottom of unprotected wood or metal
cabinet, or allow a 24” minimum when bottom
of wood or metal cabinet is protected by no
less than 1/4” thick flame retardant millboard
covered with not less than No 28 MSG sheet
metal, (.015”), .015” thick stainless steel, .024”
aluminum or .020” copper.
C.
This appliance has been approved for 0”
spacing to adjacent surfaces above the
cooktop. However, a 2” minimum spacing to
surfaces less than 15” above the cooktop and
adjacent cabinet is recommended to reduce
exposure to steam, grease splatter and heat.
To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage
space above the cooktop should be avoided. If cabinet storage space is to be provided above the
cooktop, the risk can be reduced by installing a range hood that projects at least 5” beyond the
front of the cabinets. Cabinets installed above the cooktop must be no deeper than 13”.
25 7/8" w/o handle
28 1/8" w/ handle
4 3/4” or 1/4"
36” +/- 1/2”
45 5/8”
24”
0” Min.
to cabinets
below
cooktop
30”
Min.
24”
13”
8”
24”
4”
19 3/8”
24”
2 5/16”
Side Wall
See
Note C
See Note C
(both sides)
Electrical
supply
36”
FOR YOUR SAFETY:
WARNING
Before beginning
the installation, switch power off at
service panel and lock the service
disconnecting means to prevent power
from being switched on accidentally.
When the service disconnecting
means cannot be locked, securely
fasten a prominent warning device,
such as a tag, to the service panel.
If you did not receive an anti-tip bracket with your
purchase, call 1.800.626.8774 to receive one at
no cost. (In Canada, call 1.800.561.3344.) For
installation instructions of the bracket,
visit:
GEAppliances.com
.
(In Canada,
GEAppliances.ca
.)
Anti-Tip Bracket
Kit Included
• A child or adult can tip the range and be killed.
• Verify the anti-tip bracket has been properly
installed and engaged.
• Ensure the anti-tip bracket is re-engaged when
the range is moved.
• Do not operate the range without the anti-tip bracket
in place and engaged.
• Failure to do so can result in death or serious burns
to children or adults.
Tip-Over Hazard
WARNING