Haier QGSS740BNTS LP Conversion Kit

(A) Soft blue flames—

Normal for natural gas

(B) Yellow tips on

outer cones—

Normal for propane gas

BURNER OUTPUT RATINGS: BTU/HR

Propane Gas 10” W.C.P.

BURNER

BTU

RATE

ORIFICE

SIZE (in)

COLOR

MARKING

LF

15,000

0.045

Orange/Silver

114L

LR

5,000

0.026

Red/Yellow

66L

RF

15,000

0.045

Orange/Silver

114L

RR

9,500

0.0365

Orange/Light Blue

92L

Broil

13,500

0.042

Grey

042L

Bake

16,000

0.047

Orange

0.047

To adjust your range for use with propane gas, follow these

instructions:

1. Disconnect all electrical power, at the main circuit breaker or

fuse box.

CONVERTING THE PRESSURE REGULATOR

Remove the warming drawer and panel behind drawer. The

pressure regulator is located in the lower, left hand rear corner

of the range as viewed from the front.

1.

Use an adjustable wrench to unscrew the hex-nut cap from

the pressure regulator.

threaded metal cap.

3.

Turn the metal cap so the type of gas being converted to is

displayed and replace the protective plastic cover.

4.

Screw the hex-nut cap back into the regulator.

(Do not over tighten)

TOOLS REQUIRED:

• Adjustable wrench

• Socket wrench with

1/2” socket and extension

• Phillips head screwdriver

• Flat bladed screwdriver

(blade approximately

3/32” across)

• Nut drivers: 1/4”, 9/32”

or 7mm

Pressure Regulator

Gas Valve

PROPANE

NAT

Rotate cap counter-

clockwise to loosen

Cap assembly

Regulator

WARNING

Do not operate the cooktop or oven

burners of this range when using propane (bottled) gas

for propane gas use. Failure to do so could cause high

natural gas. To use propane gas, the regulator and burner

the back of the range in the location shown.

screwed into the gas supply tubes.

along with these instructions, and replace onto the back of the

range for possible future conversion.

Propane Conversion Kit

PROPANE CONVERSION INSTRUCTIONS

31-2000678

Rev. 0

01-20

GEA

QGSS740

LR

Propane

Red/Yellow

RR

Propane

Orange/Light Blue

RF

Propane

Orange/Silver

LF

Propane

Orange/Silver

95

III

Denotes 0.95mm Orifice size opening

Denotes LP (Propane)

CHECK SURFACE BURNERS

Push and turn a knob to the LITE position. A clicking sound

indicates proper operation of the ignition system. When lighting

from only the one selected. Once air is purged from the supply

line, burner should light within 4 seconds. After burner lights,

rotate the knob out of the LITE position. Try each burner in

succession until all burners have been checked.

Quality of Flames

should look like (A) or (B).

show signs of an orange tint when well heated or signs of

WARNING

Explosion Hazard

Death or serious injury can result from failure to follow

these instructions.

• Service by a qualified service technician only.

• Shut off gas supply and disconnect power before servicing.

• Reconnect all grounding devices after service.

• Replace all parts and panels before operating.

A.

Remove the top grates, burner caps and burner heads.

B.

Using a 7 mm or 9/32” nut driver, remove the top burner

opening in the base.

NOTICE:

Round burner

Burner cap

Burner head

Base

through this

opening

To aid in identifying the proper location for the propane

Gas, color codes have been added to the side or top of the

series of engraved marks (I, II, III . . .) located on the top.

PROPANE CONVERSION INSTRUCTIONS

CONVERTING THE COOKTOP BURNERS

Haier QGSS740BNTS LP Conversion Kit

Haier QGSS740BNTS Manual

Haier QGSS740BNTS manual content summary: