Haier QSS740RNSS Installation Instructions
Haier QSS740RNSS Manual
 |
View all Haier QSS740RNSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier QSS740RNSS manual content summary:
- Haier QSS740RNSS | Installation Instructions - Page 1
In Canada, visit cafeappliances.ca. BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instruc- tions off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means - Haier QSS740RNSS | Installation Instructions - Page 2
3 ELECTRICAL REQUIREMENTS WARNING This appliance must be properly grounded. WARNING All new constructions, mobile homes, recreational vehicles and installations where local codes do not allow grounding through neutral, require a 4-conductor UL-listed range cord. WARNING To prevent fire or shock, do - Haier QSS740RNSS | Installation Instructions - Page 3
strap must be connected as shown below for the range to be properly grounded. Do not remove the ground strap. Failure follow this instruction may result in potential shock hazard. Terminal block (appearance may vary) Neutral terminal Power Cord WARNING Fire hazard Terminal block screws must be - Haier QSS740RNSS | Installation Instructions - Page 4
a properly installed anti-tip bracket. See installation instructions shipped with the bracket for complete details before fuses are replaced. • Be sure power is in service to the building. • Check that all packing . If they do not, see the Owner's Manual for proper replacement. • Check to make sure - Haier QSS740RNSS | Installation Instructions - Page 5
Instrucciones de instalación Cocinas eléctricas empotrables ¿Preguntas? Visita cafeappliances.com. En Canadá, visita cafeappliances.ca. ANTES DE COMENZAR Lea estas instrucciones por completo y con detenimiento. • IMPORTANTE - Guarde estas instruccio- nes para el uso de inspectores locales. • - Haier QSS740RNSS | Installation Instructions - Page 6
3 REQUERIMIENTOS ELÉCTRICOS ADVERTENCIA Esta unidad debe contar con una adecuada conexión a tierra. ADVERTENCIA Todas las construcciones nuevas, casas rodantes, vehículos recreativos e instalaciones donde los códigos locales no permiten una conexión a tierra a través de un neutral requieren un cable - Haier QSS740RNSS | Installation Instructions - Page 7
5 INSTALACIÓN DEL BORDE TRASERO Para todas las instalaciones, instale el borde trasero requerido en la parte trasera de la cocina con los 4 tornillos provistos. Parte Trasera de la Cocina Borde Trasero Tornillos 6 INSTALACIÓN DE TRES (3) ALAMBRES (LA CONEXIÓN A TIERRA SE REALIZA A TRAVÉS DEL - Haier QSS740RNSS | Installation Instructions - Page 8
hayan calentado. • Controle que la puerta y el cajón se encuentren paralelos y que los dos funcionen correctamente. Si no es así, consulte el Manual del propietario para un reemplazo adecuado. • Controle que la pata de nivelación trasera esté bien introducida dentro del soporte anti-volcaduras y que
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
— Save these instruc-
tions for local inspector’s use.
•
IMPORTANT
— Observe all governing
codes and ordinances.
•
Note to Installer
– Be sure to leave these
instructions with consumer.
•
Note to consumer
– Keep these
instructions for future reference.
•
Skill level – Installation of this appliance
requires a qualified installer or electrician.
•
Proper installation is the responsibility of the
installer.
•
Product failure due to improper installation is
not covered under warranty.
FOR YOUR SAFETY:
If you did not receive an anti-tip bracket with your purchase,
visit
cafeappliances.com
(In Canada,
cafeappliances.ca
).
Installation Instructions
Electric Slide-In Ranges
MATERIALS YOU MAY NEED
TOOLS YOU WILL NEED
(UL Listed 40 AMP)
4-Wire Cord 4’ long OR
3-Wire Cord 4’ long
Squeeze Connector
(For Conduit Instal-
lations Only)
1
REMOVE PACKAGING MATERIALS:
Failure to remove packaging
materials could result in damage to the appliance. Remove all packing parts from oven,
racks, heating elements and drawer. Also, remove protective film and labels on the outer
door, cooktop and control panel.
Drill with 1/8” Bit
Safety Glasses
Adjustable Wrench
Level
Tin Snips
Tape Measure
Pliers
1/4” Nut Driver
Questions? Visit cafeappliances.com. In Canada, visit cafeappliances.ca.
2
PREPARE THE OPENING (FOR INDOOR USE ONLY)
See illustrations for all rough-in and spacing dimensions. The range may be placed with 0”
clearance (flush) at the back wall and side walls of the cabinet.
NOTE:
Use a 4’ power cord to prevent interference with
the storage drawer. Power cords 4
1
2
’ to 6’ long may
have to be dressed to allow for proper drawer closing.
MINIMUM DIMENSIONS BETWEEN COOKTOP,
WALLS AND ABOVE THE COOKTOP:
A.
Make sure the wall covering, countertop, flooring and
cabinets around the range can withstand the heat
(up to 200°F) generated by the range. 0” to cabinets
below cooktop and at the range back.
B.
Allow 30” minimum clearance between surface units
and bottom of unprotected wood or metal cabinet, or
allow a 24” minimum when bottom of wood or metal
cabinet is protected by no less than 1/4” thick flame
retardant millboard covered with not less than No. 28
MSG sheet metal, (.015”), .015” thick stainless steel,
.024” aluminum or .020” copper.
C.
This appliance has been approved for 0” spacing to
adjacent surfaces above the cooktop. However, a 6”
minimum spacing to surfaces less than 15” above the cooktop and adjacent cabinet is recom-
mended to reduce exposure to steam, grease splatter and heat.
To reduce the risk of burns or fire when reaching over hot surface elements, cabinet storage space
above the cooktop should be avoided. If cabinet storage space is to be provided above the cooktop,
the risk can be reduced by installing a range hood that projects at least 5” beyond the front of the
cabinets. Cabinets installed above the cooktop must be no deeper than 16”.
Anti-Tip Bracket
Kit Included
WARNING
Before begin-
ning the installation, switch power off at
service panel and lock the service dis-
connecting means to prevent power from
being switched on accidentally. When
the service disconnecting means cannot
be locked, securely fasten a prominent
warning device, such as a tag, to the
service panel.
• A child or adult can tip the range and be killed.
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
Tip-Over Hazard
WARNING
A
C
B
A
C
Both
Sides
30”
Install the
outlet box
on either
side of the C
L
36
1
4
” ±
1
4
”
1
1
8
”
47
3
4
”
27
1
4
”
w/o handle
29
1
4
”
with handle
30”
3”
3”
3”
9”
8”
4”
7
1
2
”
2
1
4
”
2
1
4
”
Recommended
acceptable
electrical outlet
area. Orient the
electrical receptacle
so the length is
parallel to the floor.