Haier WQP12-ABM2 User Manual
Haier WQP12-ABM2 Manual
 |
View all Haier WQP12-ABM2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier WQP12-ABM2 manual content summary:
- Haier WQP12-ABM2 | User Manual - Page 1
Installation 600mm Electrical,drain and water supply line entrances must be confined to shaded areas to avoid interference with components. 820mm Most of the installation work should be done before the dishwasher is moved into place .First,select a location as close to the sink as possible for - Haier WQP12-ABM2 | User Manual - Page 2
to avoid bending or crimping it.Use the speical plastic support that comes with the appliance (see fig .C).The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. ON OFF S WQP12-ABM2 R MAX 100 MIN 40 fig.C Electrical Connection After making - Haier WQP12-ABM2 | User Manual - Page 3
its place and tighten the water supply hose back into position. Troubleshooting It may occur that the dishwasher does not The Dishwasher Does turned on. does not function and/or the problem persists, contact the nearest authorised service centre The Dishwasher Does Not Load Water and provide - Haier WQP12-ABM2 | User Manual - Page 4
Wash Cycle Table Cycle Heavy Duty Button Cycle Selection Information Desciption of Cycle Very dirty dishes,pots and pans(not to be used with delicate items). Pre-wash with hot water.(45 Exteded wash at 65 Rinse with cold water. Rinse with hot water at 70 Detergent Rinse Aid 30gr. Heavy Duty - Haier WQP12-ABM2 | User Manual - Page 5
Starting the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled,"Loading the Dishwasher"). - Pour in the detergent (see the - Haier WQP12-ABM2 | User Manual - Page 6
Detergent specifically intended for use with dishwashers must be used.The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table."The detergent dispenser is located on the inside panel the door. Loading the detergent To open the - Haier WQP12-ABM2 | User Manual - Page 7
being used in order to optimize and customize the level of salt consumption while keeping it to a minimum. To adjust salt consumption level , follows these instructions: - Unscrew the cap on the salt container; - On the container there is an arrow (see fig ure to the side).If necessary,turn the - Haier WQP12-ABM2 | User Manual - Page 8
read the instructions contained in this manual,as they provide section entitled, "Troubleshooting."If you cannot resolve the problem,contact a service centre. - Only available from the manufacturer or its service agent. Close-up View (control panel) A B C ON OFF S WQP12-ABM2 R F E D A ON - Haier WQP12-ABM2 | User Manual - Page 9
Installation Domestic Dishwasher WQP12-ABM2 CONTENT Safety Is a Good Habit to Get Into 1 Close-up View (control panel) 2 Close-up View (Interrior) 3 Salt°≠ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ 10 Cleaning and Special Maintenance 11 Troubleshooting 12 Installation 13 CODE : 0120500373
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
600mm
820mm
600mm
open
Electrical,drain and
water supply line en-
trances must be con-
fined to shaded areas
to avoid interference
with components.
Most of the installation work should be done be-
fore the dishwasher is moved into place .First,se-
lect a location as close to the sink as possible for
ready access to water and drain lines. For proper
operation and appearance of the dishwasher,the
cabinet opening should be square and have dimen-
sions as shown in Fig. 1.lf the dishwasher is to be
installed in a corner,there must be sufficient clear-
ance to open the door as shown in Fig. 2.A mini-
mum clearance of 2" is recommended.
Rough-in the water,electrical,and drain lines before
proceeding with the installation. The lines should
run straight to their connections on the dishwasher.
Note:Make sure that the lines do not cross in
front of the dishwasher motor or its legs.
Fig.1.
Fig.2.
Installation