Haier XPB60-DS User Manual
Haier XPB60-DS Manual
 |
View all Haier XPB60-DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Haier XPB60-DS manual content summary:
- Haier XPB60-DS | User Manual - Page 1
User's manual XPB60-DS Air Bubble Twin-tub Washing Machine with Pump Contents Before using Names of the parts will not bear the responsibility for those risks occurred from not obeying this manual. Trouble-shooting* Answers to question 15 Packing list 17 Specification the back cover - Haier XPB60-DS | User Manual - Page 2
tub Inner cover of the spin tub Spin timer Spin tub frame Spin tub Cabinet Earthing cord Power cord Accessories Water-filling jointer (one piece) Lint filter (one piece) Water inlet hose (one piece) Gland (one piece) Meaning and description of the symbols Warning sign Contents marked with that - Haier XPB60-DS | User Manual - Page 3
replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean. In case the the washing machine Do not use water hotter than 50 C . Do not put the machine at damp place Do not wash water-proof laundries such like the bathroom - Haier XPB60-DS | User Manual - Page 4
. Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not wash laundries with volatile materials (such as thinner, petrol etc.). Petrol Thinner Handicapped or children without care shall - Haier XPB60-DS | User Manual - Page 5
Installation and adjustment Before Using Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. The drainage shall be smooth with the drain hose. 1.The height of the - Haier XPB60-DS | User Manual - Page 6
hose at the two sides of the cabinet.) (See to Figure 4). Figure 4 Install the water inlet hose; Select the water level Insert the water inlet hose into the water-filling entrance on the control panel, then push the water-filling jointer into the entrance on the control panel. (To dismantle the - Haier XPB60-DS | User Manual - Page 7
spinning to Spin remove the extra detergent liquid. It Foam-removing spinning can both shorten the washing time and save the water consumption. Fill water for about 1 minutes Spin for about 1~2 minutes Remove most of the foam extra detergent liquid. Remove the detergent liquid remained The - Haier XPB60-DS | User Manual - Page 8
washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3.Put the drain hose up to the suitable position. 4.Slanting or uneven ground may result in unstable working or abnormal noise. Please make the - Haier XPB60-DS | User Manual - Page 9
laundries and the laundries can be turned round in washing for one time washing. Do not select " Maximum " water level for laundries less than 2.4kg, so as to avoid splashing of water. Working suit up,down cotton,about 1120g Blanket cotton,about 900g Jeans about 800g Pajamas Blending coat about - Haier XPB60-DS | User Manual - Page 10
The whitener shall not touch the laundries directly. Refer to the user's manual for the usage and quantity of the whitener. For powder whitener, instruction of the washing powder for the detail dosage. Selection of the quantity of the washing powder list 1 Laundries quantity Water level Water - Haier XPB60-DS | User Manual - Page 11
timer (To set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of the timer). Wash selector (Standard current, strong current) Water-filling entrance Buzzer (The buzzer will ring when the washing finishes) Spin timer (to set to below 1 minute, first - Haier XPB60-DS | User Manual - Page 12
cover of the spin tub. (2) Set the water-filling selector control rod at the "SPIN" side. Fill water for about 1 minute. If the water quantity filled is too large, the water may flow out from the wash tub side. Please twist the water tap to limit the water filling. (3) Close the outer cover of the - Haier XPB60-DS | User Manual - Page 13
the wash timer to 5-7 minutes to do rinsing. OVERFILL If you find water flowing out here,please twist the water tap to limit the water filling. Rinse with stored water (Repeat the midway spinning and rinsing with stored water for 2-3 times) 1. Put the laundries into the wash tub. Select suitable - Haier XPB60-DS | User Manual - Page 14
work if you open the outer cover of the spin tub. Close it to resume the spinning. To do spinning and draining or rinsing with water-filling together, please first do spinning for around 1 minute, then do draining or rinsing with - Haier XPB60-DS | User Manual - Page 15
the lint filter Put hand at the indicated position. Push down to take it off. ( See to Figure 1) Figure 1 2. Clean the lint Put it in water and clean while it is still wet.(See to Figure 2) 3. Install the lint filter After cleaning, insert the bottom of the lint filter ( marked with - Haier XPB60-DS | User Manual - Page 16
after each using. Pull off the power plug and hang up the power cord. Hang up the drain hose. Wipe off the water drops on the surface and inside the tub with clean soft cloth. Open the cover of the wash tub and the inner/outer cover of - Haier XPB60-DS | User Manual - Page 17
Trouble-shooting Answers to question If the laundries fall to the outer side "STANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to melt. When the water is frozen Pour hot water below 50 into the wash tub to soak it completely. Then turn the pulsator with hands - Haier XPB60-DS | User Manual - Page 18
Trouble- breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. There's abnormal sound and violent vibration during spinning There may be some water flowing out of the drain hose in the first use of the machine - Haier XPB60-DS | User Manual - Page 19
Packing list User's manual Water inlet hose Water-filling jointer Gland Lint filter Air bubble twin-tub washing machine with pump One One One One One One - Haier XPB60-DS | User Manual - Page 20
Specification Type Model Power source Water level Water quantity about Rated washing capacity kg Rated spinning capacity kg Rated input power W Dimension(mm) Wash pattern Weight kg Injection pressure Air BubbleTwin-tub Washing Machine with Pump XPB60-DS Rated voltage 220V~,Rated frequency 50Hz
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
XPB60-DS
Air Bubble Twin-tub Washing Machine
with Pump
Names of the parts
.............
the 2
nd
cover
Safety precautions
...............................
1
Installation and adjustment
..................
3
Introduction of the major functions
.......
5
Preparation
before washing
................
6
The musts in washing
.........................
7
Usage of
the detergent
.......................
8
Washing sequence
..............................
9
Disposal after washing
.......................
13
Contents
Before using
Using
process
User's
manual
Trouble-shooting*
Answers to question
.....................
15
Specification
...............
the back cover
Packing list
......................................
17
Please read this manual carefully before using.
Retain it for future reference
Please check if the power receptacle has goodearthing
condition before using to guarantee your safety.
The manufacturer will not bear the responsibility for
those risks occurred from not obeying this manual.