Harman Kardon CITATION V Owners Manual
Harman Kardon CITATION V Manual
View all Harman Kardon CITATION V manuals
Add to My Manuals
Save this manual to your list of manuals |
Harman Kardon CITATION V manual content summary:
- Harman Kardon CITATION V | Owners Manual - Page 1
Se •• rt I •..:e.cs •;3'6", ff/. ftii •S i• • t4'S4:4q1t--k st'.• NA,* 4t' Sti 41 . • 44k •an •"+;-.• • .) s•le A tr STEREOPHONIC AMPLIFIER k. ts• harman• kardon - Harman Kardon CITATION V | Owners Manual - Page 2
this magnificent instrument. Although the Citation V will perform satisfactorily with any high manual. These may be attached to the wall opposite your workbench for easy reference. After studying the manual amplifier that performs perfectly the first time it is connected. KEEP THIS INSTRUCTION MANUAL - Harman Kardon CITATION V | Owners Manual - Page 3
V is a smaller version of the powerful Citation II. This magnificent new basic power amplifier has every worthwhile feature required for superb sterophonic reproduction. * Conservatively rated at 40 watts RMS per channel with 95 watt peaks at less than 0. 5% distortion. * Clips clean without - Harman Kardon CITATION V | Owners Manual - Page 4
HARMONIC DISTORTION: Less than 0. 5%, 20-20,000 cycles per second at 40 watts. Unmeasurable at normal listening level. INTERMODULATION DISTORTION: Less than 0. 5% at 40 watts. FREQUENCY RESPONSE: SENSITIVITY: 7-45,000 c.p.s. -0, -1.0 db at 40 watts. 2-80,000 c.p.s, -F--0, -1.0 db at 1 watt. 1.2 - Harman Kardon CITATION V | Owners Manual - Page 5
of the parts have been unpacked, check them against the master parts list in this manual to make certain all parts are present and parts supplied with Harman-Kardon Citation Kits are guaranteed by the manufacturer to be free from defects in material and workmanship when put to normal use and service - Harman Kardon CITATION V | Owners Manual - Page 6
be of value. The Harman-Kardon warranty station will inspect and service your kit at a minimum service charge of $10 plus the cost of parts or tubes that are out of warranty, provided the unit has been constructed and completed in accordance with the instructions in this manual. This special repair - Harman Kardon CITATION V | Owners Manual - Page 7
watt range. You may choose either the standard diamond or chisel tip. Always keep the tip clean and properly tinned in accordance with the manufacturer's instructions soldering a joint having a small component connected to it, the part may be protected from excessive heat produced by the iron by - Harman Kardon CITATION V | Owners Manual - Page 8
to the part to be soldered before the actual connection. ) When the instructions call for the use of a "white/black" wire it means a white wire with a black spiral tracer. When the instructions call for a "black/white" wire it means a black wire with a white spiral tracer. This Citation amplifier is - Harman Kardon CITATION V | Owners Manual - Page 9
RESISTOR HOLDING CARD The cards on which the resistors and small condensers are mounted may serve as a convenient holder during construction. Remove the tape by peeling it free from the resistor leads, holding the body of the resistors down to prevent them from being pulled out of the holder. Bend - Harman Kardon CITATION V | Owners Manual - Page 10
Slip sleeving over all the capacitor leads as shown in the pictorial. Connect to the bottom section of the lugs wrapping tightly one complete turn. Crimp and clip off any excess bare ends. Bands on condenser body indicates outside foil. Polarity is unimportant. REFER TO FIGURE B. STEP # ASSEMBLY - Harman Kardon CITATION V | Owners Manual - Page 11
au!M$SY CHICK 10 ) 11 ( ) 12 ( ) 13 ( ) 14 ( ) 15 ( ) 16 ( ) f ) Hook the cathode lead from SD-1 with the anode lead from SD-2 as shown in the connecting detail (S-2). Cut off excess wire. FRAGILE!!! Use caution handling leads. ( ) Hook anode lead from SD-3 with cathode lead from SD-4 (5-2). Cut - Harman Kardon CITATION V | Owners Manual - Page 12
Leave the other end free. ( ) Cut the lead on one end of a 33 ohm 1/2 watt 5% resistor (orange, orange, black, gold) to "2" and connect this end to T6-1 (S-4). Leave ) Dress the remaining black, white/red and gray wires, which are part of the harness, as shown and tape at Point C. This completes - Harman Kardon CITATION V | Owners Manual - Page 13
REFER TO PICTORIAL #4. CHASSIS ASSEMBLY In order to prevent marring of the fine finish of the Citation V, it is suggested that the work bench be cleared and covered with one of the flat filler pieces originally used in the packaging of this - Harman Kardon CITATION V | Owners Manual - Page 14
NS) T8-1 (NS) 18 ) ( ) Brown/white 6" T8-1 (NS) V6-5 (S-1) 19 ( ) ( ) Connect a 1 ohm 1/2 watt 10% resistor (brown, black, gold, silver) from T8-2 (S-3) to VG -6 (S-1). 20 ( ) ( ) Connect a 1 ohm 1/2 watt 10% resistor (brown, black, gold, silver) from T8- I (S-3) to V5-4 (S-1) and 21 ( ) 22 - Harman Kardon CITATION V | Owners Manual - Page 15
10% brown, black, green, silver brown, black, green, silver V2-2 (S-2) V6-2 (S-2) 40 ( ) ( ) 3.3 ohm 1.2 watt 10% orange, orange, gold, silver V3-8 (NS) 41 ( ) ( ) 3.3 ohm 1/2 watt 10% 42 ( ) ( ) 3.3 ohm 1/2 watt 10% orange, orange, gold, silver orange, orange, gold, silver V4-8 (NS) V8-8 (NS - Harman Kardon CITATION V | Owners Manual - Page 16
REFER TO PICTORIAL #5. STEP #ASSEMBLY CHECK With a long nose pliers carefully bend fuse side tab F1-2 on fuse holder. Connect the black wire from PT-1 to Lug #2 (S-1) on fuse holder Fl. Connect white/black wire from PT-1 to Lug #2 (NS) on Lug strip T4. Insert line cord into hole in rear of chassis - Harman Kardon CITATION V | Owners Manual - Page 17
ELECTROLYTIC BRACKET INSTALLATION AND WIRING REFER TO PICTORIAL #6. STEP t±ASSEMBLY CHECK 1 () ( ) Place the electrolytic bracket in the chassis and align with the mounting holes. All the 9 leads which are in the grommet should pass through the large round cut-out. Move the grommet to align with - Harman Kardon CITATION V | Owners Manual - Page 18
(S-1) ( ) Gray 6 1/2" P6-1 (S-2) ( ) Gray/white 8" P6-3 (S-2) ( ) Yellow 8" P7-1 (S- 2) ( ) Yellow/white 6 1/2" P7-3 (S-2) ( ) Connect the free end of one of the 33 ohm 1/2 watt 5% resistors (orange, orange, black, gold) to V4-7 (S-3). ( ) Connect the free end of the other 33 ohm - Harman Kardon CITATION V | Owners Manual - Page 19
TERMINAL BOARD INSTALLATION AND WIRING REFER TO PICTORIAL #7. STEP # ASSEMBLY CHECK 1 ) ( ) Mount terminal board "B1' to chassis, Slip #6-32 x 2" screw thru chassis, place tubular spacer over screw, mount board and fasten with #6 lockwasher under #6-32 hex nut. Observe orientation of board, - Harman Kardon CITATION V | Owners Manual - Page 20
Make the following connections to the terminal boards with the (LI) wires which are coming from the tube sockets. Connect to the bottom section of the terminal lug. Wrap one full turn and then crimp to insure a mechanically secure connection STEP =ASSEMBLY CHECK COLOR FROM PIN # TO LUG # 17 ( - Harman Kardon CITATION V | Owners Manual - Page 21
of a 44K ohm 7 watt 10% resistor (value marked AMPLIFIER TO AN AC OUTLET UNTIL YOU HAVE READ THE PARAGRAPH ON FINAL INSPECTION. STEPS ASSEMBLY 1 () 2 () 3 () 4 () 5 () 6 () 7 () FINAL INSPECTION Visually inspect all connections and wiring comparing against the master charts and manual other parts. - Harman Kardon CITATION V | Owners Manual - Page 22
PICTORIAL 9 4'6 -32 X1/4 LG. SELF TAPPING SCREW # 6 FLAT WASHER a aa aaa s a a a aED ou.,,. a ss a a D a S a S a a s as aaaa _ a a '.% aa a a cue a a aa s a a aa saa e(3 s a S s a S S ea S eE3 a aaaaaaa®aa a s E3 s a a a a a a aa a s s a kEi4 a a ) a e5> a a ,E a a S - Harman Kardon CITATION V | Owners Manual - Page 23
into a 117 volt 60 cycle source. The tube filaments should light. amplifier to warm up for approximately ten minutes. Allow the A WORD OF end of this cord into the Channel "A" input jack. As the 16 ohm 20 watt resistor will get quite hot, prolonged testing is not advisable. ) Slide and hold - Harman Kardon CITATION V | Owners Manual - Page 24
instructions Amp, Harman-Kardon, Inc. , Citation Kit Division, Plainview, L. I. , New York and give all symptoms, voltage and resistance readings and describe your difficulty in detail. State model and serial number. You will receive our prompt reply to help solve your problem. 9. Our factory,service - Harman Kardon CITATION V | Owners Manual - Page 25
if possible, to obtain optimum results. As this power amplifier is rated at 40 watts per channel, it is advisable to use speakers with monophonic or stereophonic preamplifier to the power amplifier. The Harman-Kardon Citation I and Citation IV stereophonic preamplifiers incorporate circuitry which - Harman Kardon CITATION V | Owners Manual - Page 26
Citation V as a 80 watt monophonic amplifier plug, part #A-754 to parallel the inputs of the amplifier. This device amplifier. The cover is supplied with complete mounting instructions. FUSE In the event of a potentially damaging failure of tubes or components, the Citation V is protected by a 6 amp - Harman Kardon CITATION V | Owners Manual - Page 27
OT-2 Power Transformer Output Transformer COMPONENTS, SMALL PARTS, ETC. P3714388 P3714390 STCOM4513 STCOM4514 STCOM3749 , Terminal Strip Fuse Holder (with nut, lock and rubber washer) Fuse 6 Amp, MTH Meter Meter Switch Electrolytic Insulator Potentiometer Solder Shield AC and DC Balance Controls - Harman Kardon CITATION V | Owners Manual - Page 28
PART NUMBER PARTS PER KIT ZCOM3679 4 7581 - 6 C 6 tp- 4 12BY7A 2 6CG7 2 Z3714398 1 KM4-40-6SB, 8 KL4-SC KN4-40SC 8 KM6-32 6SB 47 KM6-32-20SB 1 KM6-32-32SB 6 - Harman Kardon CITATION V | Owners Manual - Page 29
PART NUMBER PARTS PER KIT CODE DESIGNATION RESISTORS DESCRIPTION watt 10% (value marked on body) 180 ohm 3 watt 10% (value marked on body) 390 ohm 1 watt 10% (orange, white, brown, silver) 16 ohm 20 watt 20% (value marked on body) 33 ohm 1/2 watt 5% (orange, orange, black, gold) 1 ohm 1/2 watt
rt
NA
,*
tr
Se
••
4'
t
Sti
A
41
.
•
•an
•
I
•'
;6
3
"
,
•
..:es
c
.
••
S.
,•>•i•
ff.
/
•
t4‘
Sqt
-
4:41-k
4
4
k
•"+;-.•
.)
•••••:sle
•
ftii
st
.•
'
STEREOPHONIC
AMPLIFIER
•
••
••••••,-
,
ts
•
k.
harman•
kardon