Harman Kardon HS 300 Owners Manual

Harman Kardon HS 300 Manual

Harman Kardon HS 300 manual content summary:

  • Harman Kardon HS 300 | Owners Manual - Page 1
    ® Power for the Digital Revolution.® HKTS 11 HOME THEATER SPEAKER SYSTEM OWNER'S MANUAL
  • Harman Kardon HS 300 | Owners Manual - Page 2
    HKTS 11 HOME THEATER SPEAKER SYSTEM 3 Safety Information 4 Introduction 4 Included 5 SUB-TS11 Subwoofer Amplifier Panel Controls and Connections 7 Speaker Placement 7 Color-Coding System 8 Mounting Options 9 Speaker Connections 9 Speaker-Level Connection Guide 10 Dolby Digital or DTS (
  • Harman Kardon HS 300 | Owners Manual - Page 3
    servicing to qualified service personnel. Servicing home, consult your product dealer or local power company. For products intended to operate from battery power or other sources, refer to the operating instructions. 17. If an outside antenna or cable system or integral convenience receptacles,
  • Harman Kardon HS 300 | Owners Manual - Page 4
    subwoofer output. Other conve- niences include a level control, an external trigger input for automatic turn-on when connected to a compatible product, a highcut (low-pass) filter switch and a phase switch for fine-tuning complement to a Harman Kardon receiver or any home theater system. AA A
  • Harman Kardon HS 300 | Owners Manual - Page 5
    LR OUT IN IMPORTANT: CONNECT STRIPED WIRE TO RED ( ) SPEAKER TERMINAL. ¡ Subwoofer-Level Control ™ High-Cut (Low-Pass) Filter Switch £ External Trigger Input ¢ Audio- when using the Line-Level Full-Range Inputs ¶, unless your receiver or processor processes its line-level output using a lowpass
  • Harman Kardon HS 300 | Owners Manual - Page 6
    SUB-TS11 SUBWOOFER AMPLIFIER PANEL CONTROLS AND CONNECTIONS place itself in the Standby mode, depending on whether it is receiving an audio signal. When this switch is placed in the ON position, the SUB-TS11 will remain on, whether or not it is receiving an audio signal. An LED located on top of
  • Harman Kardon HS 300 | Owners Manual - Page 7
    Electronics Association to make setting up your home theater speaker system as easy as possible. Your system includes a set of colored stickers White Front Right Red Center Green Surround Left Blue Surround Right Gray Subwoofer (LFE) Purple Before you begin to connect cables, it is important
  • Harman Kardon HS 300 | Owners Manual - Page 8
    not possible, use optional wall Wires to Speaker anchors that are rated to support at least on top: a round screw hole, and an arc- shaped the correct polarity (see page 9). Referring to the speaker connection instructions on pages 9 through 12, thread the appropriate speaker cable through the
  • Harman Kardon HS 300 | Owners Manual - Page 9
    the (+) terminal and black for the (-) terminal. Newer Harman Kardon receivers conform to the new CEA standard and therefore use a color other than red or black for the (+) terminal to indicate some speaker positions: e.g., surround left. Although the HKTS 11 system has red and black collars on the
  • Harman Kardon HS 300 | Owners Manual - Page 10
    or Other Digital Surround Mode) Connection USE THIS INSTALLATION METHOD FOR DOLBY DIGITAL, DTS OR OTHER DIGITAL SURROUND PROCESSORS: Use the line-level input jack marked SUB § for the low-frequency effects channel. Connect this jack to the subwoofer output or LFE output on your receiver or amplifier
  • Harman Kardon HS 300 | Owners Manual - Page 11
    or amplifier to either the left or right Line-Level Full-Range Input ¶ on the SUB-TS11 subwoofer. Use both the left and right inputs on the subwoofer if your receiver or processor has both left and right line-level outputs. In that case, you will need to supply a second interconnect cable. If
  • Harman Kardon HS 300 | Owners Manual - Page 12
    . When all connections have been made, plug the AC power cord on the subwoofer into an AC outlet. Front Left - + Center - + SUB-TS11 Subwoofer GHHI L EVELL R Front Right - + Front Left Receiver Center Front Right Surround Left Surround Right Surround Left - + Surround Right - + 12 SPEAKER
  • Harman Kardon HS 300 | Owners Manual - Page 13
    that it is in the AUTO position. When your receiver or amplifier is off, or is not sending program material to the subwoofer, the subwoofer will be in Standby mode and the LED indicator on the top of the subwoofer will turn amber. When the subwoofer senses an audio signal, it will automatically turn
  • Harman Kardon HS 300 | Owners Manual - Page 14
    surround speakers are enabled. • Review the operation of your DVD player and the jacket of your DVD to make sure that the DVD features the desired Dolby Digital or DTS mode, and that you have properly selected that mode using both the DVD player's menu and the DVD disc's menu. 14 TROUBLESHOOTING
  • Harman Kardon HS 300 | Owners Manual - Page 15
    HKTS 11 System Frequency Response 25Hz - (102mm x 241mm x 92mm) Weight: 2.2 lb (1kg) SUB-TS11 Subwoofer Amplifier: 200 Watts, RMS Bass: 10" (250mm) Woofer, bass-reflex to change without notice. Harman Kardon and Harman International are trademarks of Harman International Industries, Incorporated,
  • Harman Kardon HS 300 | Owners Manual - Page 16
    250 Crossways Park Drive, Woodbury, New York 11797 516.255.HKHK (4545) Fax: 516.682.3523 ®® © 2006 Harman International Industries, Incorporated. All rights reserved. Part No. 406-000-05466-E Printed 8/06
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16

HKTS11
HOME THEATER SPEAKER SYSTEM
OWNER’S MANUAL
Power for the Digital Revolution
.
®
®